answersLogoWhite

0

desribe the correct tighting procedure for the wheel bearing

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Should you have to replace the wheel bearing in your Honda Civic every 26000 miles?

No, you should not. You are either tightening the wheel bearing to tightly or too loosely or the bearing race needs replacing. Take the vehicle to a professional and see what is wrong.


When you jacked up your 96 Tahoe you could wiggle the passenger wheel what could be the problem?

Might be that the nut holding the wheel bearing needs tightening or that the wheel bearing needs replacing. Going to have to take it apart to get to the bottom of this one.


What is the rear wheel bearing torque on a 95 tercel?

The rear wheel bearing torque specification for a 1995 Toyota Tercel is typically around 55 ft-lbs (75 Nm). It's important to use a torque wrench to ensure proper tightening, as over-tightening can damage the bearing. Always refer to the vehicle's service manual for the most accurate and detailed specifications.


Your passenger wheel squeaks really bad in 3rd gear?

This may be your bushells or wheel bearing. It most likely isn't only in third gear but you only notice it at a higher speed because of the vibrations. I suggest tightening the wheel bearing or replacing the side bushells


How to replace 1999 Ford Escort wheel bearing?

Your best bet is to remove the steering knuckle then take it to your local machine shop as the wheel bearing must be pressed off the hub and the knew one pressed on. Also a front end alignment shoudl be performed afterwards Good Luck Remove the front wheel knuckle Remove the inner wheel bearing oil seal Use Bearing Pulling Attachment to press the wheel hub from the wheel knuckle. Remove the retainer ring from the wheel knuckle. Use bearing puller attachment to press the wheel bearing out of the wheel knuckle reverse the removal procedure. install new inner seal


What is the proper torque specification for tightening a bike wheel bolt?

The proper torque specification for tightening a bike wheel bolt is typically between 30-40 Newton meters. It is important to use a torque wrench to ensure the bolt is tightened to the correct specification to prevent damage to the wheel or hub.


You've replaced the rear driver wheel bearing assembly it still seems to be going out What else can be the cause to your bearing problem?

Assuming this is a front wheel drive model, it could be any of the following; Rear wheel alignment off Warped rim (even slightly warped) Bad Rotor/drum Incorrect insertion of bearing race Over tightening the bearing/(rotor/drum) nut Bent spindle Bent or worn trailing arm or bushings. Bad quality Wheel Bearings.


How do you change wheel bearing on ml 320?

Remove the tire and wheel from your Mercedes-Benz. Remove the axle end. Remove the wheel bearing nuts. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new wheel bearing.


Replacing front wheel bearing new type astra?

Begin by removing the tire and wheel. Remove the and of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install your new wheel bearing.


Are wheel bearing with abs sensor same as hub with abs?

Many people call these the same but the correct answer is no.


Why do your 1999 Cougar wheel bearings keep going out every 6K miles?

Incorrect packing of bearing grease or incorrect torque. Also make sure to replace the bearing race, as it may be scored. CORRECT ANSWER- you need to replace the knuckle and the wheel bearing


How do you change a front wheel bearing on a Chevy Lumina?

Remove the tire and wheel from your Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.