0
What else can I help you with?
Can use 7 ton condenser unit hook up the 6 ton evaporator?
you can probably get away with that just make sure you have an expansion valve on the evaporator. An expansion valve will keep liquid from getting back to the compressor.
Where is the expansion valve is located on an AC system?
The expansion valve in an AC system is typically located between the condenser and the evaporator. It is usually found in the indoor unit, near the evaporator coil, or in the refrigerant line connecting the two components. This valve regulates the flow of refrigerant into the evaporator, allowing it to expand and absorb heat from the indoor air.
Major components of chiller unit?
The major components of a chiller unit include the compressor, condenser, evaporator, and expansion valve. The compressor is responsible for circulating the refrigerant through the system. The condenser releases heat from the refrigerant, causing it to condense into a liquid. The evaporator absorbs heat from the chilled water, causing the refrigerant to evaporate and cool the water. The expansion valve regulates the flow of refrigerant into the evaporator, controlling the cooling process.
Where is the expansion valve on a 1995 Lexus ES300?
It is attached to the back wall of evaporator. You have to remove the glove compartment, blower unit and evaporator to get access to the expansion valve.
When you change a home air conditioning value do you have to drain all of the freon?
That would depend on where in the system the valve is. In many instances you can pump down the unit so all of the refrigerant is in the condenser and change a valve that is on the low side of the system or indoors.
How do you determine what the sub-cooling temperature of a unit with a Thermostatic expansion valve should be?
give answer
Where is the AC condenser unit located?
The AC condenser unit is located right in front of the radiator.
Why is the small copper pipe cold and larger copper pipe hot at the outside unit?
The small copper pipe is the liquid line carrying refrigerant from the condenser unit to the evaporator coil inside, so it is cooled down by the expansion of the refrigerant inside it. The larger copper pipe is the suction line carrying warm refrigerant vapor from the evaporator coil to the condenser unit, so it feels hot due to the heat absorbed during the cooling process.
How do you perform basic maintenance on a home AC unit?
Change the indoor filter, wipe the indoor unit down, and spray off the condenser
Where is the orifice tube on 1999 ford e350 rear ac?
its an expansion valve and it is located in the black box ( in the rear unit)
Can air conditioner compressor on a 1999 dodge Dakota 5.2 liter be rebuilt?
No, it's best to buy a new factory unit but when your compressor goes bad you will also need to change the dryer,expansion valve and outside condenser unit as well, because of debris from the compressor. Some mechanics will try and flush the system or use air to blow out the debris but in the end the customer will be back with the same trouble again. It is possible to buy used compressor and o/s condenser but always buy new expansion valve and dryer and save a little money you just don't get a warranty.I have done this for over thirty years but I could be wrong, so do the job right and stay cool all summer.
How do you replace the expansion valve on a 92 Honda civic?
The expansion valve is found inside the evaporator housing. To replace the AC system needs to be flushed legally. Then valve is only held down by a few mounting screws. Once the AC system is bled, loosen the screws and replace the unit.
