answersLogoWhite

0

57 - 61 psi for the 95 jimmy 4.3 vortec so it is probable the same

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the tensioner for the fan belt on a 1994 Jimmy Vortex?

It's on the top, front, center of your engine. between the a/c compressor and the alternator.


Does Jimmy Neutron and Cindy Vortex marry?

They are children throughout the series obviously, but in the future-centric episode, The Tomorrow Boys, they aremarried.


Where is the ac low pressure port in a 98 jimmy?

The 1998 GMC Jimmy air-conditioner low pressure for is located on the top of the air conditioner compressor. The low pressure port will be marked as such.


How do you put freon in a 1994 gmc jimmy?

To add Freon to a 1994 GMC Jimmy, first locate the low-pressure service port, typically found on the larger diameter aluminum line connected to the AC compressor. Ensure the AC system is off, then attach the refrigerant can's hose to the port. Start the engine and turn the AC to the maximum setting, then slowly open the can to allow Freon to flow into the system. Monitor the pressure gauge on the can to avoid overfilling, and discontinue when the system reaches the recommended pressure.


Where is the fuel pressure regulator on a 98 jimmy?

in the intake manifold


What is the normal running temperature for a 1999 Jimmy?

195 degrees F


Where is the map sensor located at on a 1994 S10 Blazer 4.3 vortec?

The manifold absolute pressure (MAP) sensor is an important component to your 1994 General Motors Blazer/Jimmy's EFI system. This pressure sensor is located provisioned into the intake manifold assembly.


Fuel pressure spec for 1999 gmc jimmy?

60-66 psi


Standard fuel pressure for a 1997 GMC Jimmy 4.3L?

60 to 66 psi


Fuel system on 1987 gmc jimmy?

what is it that you need to know about it?, I have a 1989 GMC Jimmy 4.3L, if the system is the same then I can help a bit, doing some work on it at the moment, replacing the pump.


What would cause the oil pressure gauge on your 1991 S15 jimmy not to work and how do you fix it?

Have you change the oil pressure sending unit, that's what I had to do. David


How do you repair the brakes in a 1988 GMC Jimmy?

I have replaced the entire brake system in a 1988 gmc jimmy and still have no brakes can you help/

Trending Questions
Where can you find a diagram of how the t-tops in a 1995 Pontiac Firebird go into the holders in the trunk? Why does a dodge charger have two batteries? Where online is there a Corvette forum? How do remove tailgate panel gm envoy? What is the oil capacity of a 1997 Mercury Villager 3.0 liter engine? What are all potential causes of steering wheel vibration what intensifies with speed in a 2000 dodge neon? How do you reset passlock for 2001 Chevrolet Impala? What is the meaning of a brake light on 1994 mustang instrument panel? How to remove door panel from a 1989 Chevy Blazer? How do you replace fuel injectors on a 1998 grand prix gtp? What is the transmission fluid capacity for a 1993 Mercury Sable? What does it mean when there is a constant humming like an electric motor coming from above the fuel tank on a 1999 Chevy Suburban while its running and goes off when key is just in the on position? What does the differential look like? Where is the Most common oil leak in a Ford Fiesta? What automatic transmission fits the 1959 Chevy pick up 6 cylinder engine? How much work to replace a small block Chevy with a big block Chevy? What is the recommended amount of R134 needed to recharge a 2002 Ford Escape air conditioning unit? Where is the pcv valve located on a 1998 Pontiac Sunfire 2.2L? Location of resister for blower motor on 1997 s 10 blazer? When replacing the front upper left control arm bushing on a 1991 Infiniti G20 does any part of the axle kit need to be removed and replaced?