A simple first step would be to check the fuses to these lights, then go from there.
Press both blinker directions at the same time.
Probably Flasher
Hazard lights are used on a vehicle in an emergency. The driver is supposed to turn the lights on the warn others that their car is experiencing some sort of problem.
get the whole care re wired also dont turn on your hazard lights!!!
check the brakelight switch. it is located under the dash where the brake pedal rests. Hey its ritchie. If you can click your blinker down and then they work its you blinker switch,but this is my monte.
It has been my experience that when the blinker comes on but the lights don't blink there is one or more bulbs burned out. If that is not the case check the flasher.
Put on your hazard blinker lights so that oncoming traffic will be looking for a dangerous situation ahead and will drive more carefully.
Try pushing the hazard light switch on steering column repeatedly. I had a strange problem with my hazards once and this fixed it for now. I think my problem was the signals not working though....
Start by replacing the Flasher Relay.
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
There may be a problem with your electrical wiring that is preventing your hazard lights from turning off. You should take your car to a Toyota mechanic.
If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.