answersLogoWhite

0

These rotors are sided, I would go to a parts store, and look at a pair and go from there........... .

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you remove the rotors on a 1992 ford aerostar?

How do you remove the rotors on a 1992 ford aerostar?"


2001 S10 2 wheel drive front rotors have sensors?

The front wheels have abs sensors if applicable. The sensors would be mounted to the spindles not the rotors.


Which direction do helicopter blades turn?

It depends on which way the rotors are slanted.


Your 1991 Chevy Caprice classic needs new rotors is it the front ones or the back ones It shakes when I brake.?

the rotors are front mounted brake (pads) and the rear are usually the spring type ..also known as(shoes)


Where is the speed sensor located on a 1998 GMC pickup?

mounted to the front hubs remove calipers and rotors follow the wire that runs to the hub


Should new brake pads be tight against the rotors during installation?

No, new brake pads should not be tight against the rotors during installation. There should be a small gap between the pads and the rotors to allow for proper braking performance and to prevent excessive wear on the pads and rotors.


How do I get rid of a slight vibration running 55 mph after changing the rotors in my car?

Rotors may not be balanced, calpiers may be installed incorrectly, tires may be out of balance or mounted wrong, wheels may be bent, steering linkage may be worn out or loose.


What causes brakes to shudder and how can this issue be resolved?

Brakes shudder due to uneven wear or warping of brake rotors. This can be resolved by resurfacing or replacing the rotors, and ensuring proper installation and maintenance of the brake system.


What is the name of the helicopter with two propellers used to carry supplies?

Undetermined. All helicopters have 2 rotors; usually a Main Rotor and a Tail Rotor. So, I assume you meant 2 Main Rotors of same diameter.Boeing Ch-47 Chinook - One rotor mounted in the front over the cockpit and one rotor in the rear.V-22 Osprey - Both rotors are mounted on engine pods mounted at the tips of the wings. The engines rotate from helicopter mode to airplane mode. This helicopter just went into operational service after years of development.There are helicopters with no tail rotor. It has two rotors on top. One going clockwise the other going counter clockwise. Called Coaxial rotors or co-rotors are a pair of helicopter rotors mounted one above the other on concentric shafts. The military ones look like jets so even with jet engines. Very nasty looking helicopters.They are much faster and can turn and maneuver much faster. You can look it up. Helicopters with Coaxial rotors. I do not mean the ones with the fan in the tail. These just have wings on the tail.The other one is the NOTAR is the name of a helicopter anti-torque system which replaces the use of a tail rotor. Developed by McDonnell Douglas Helicopter Systems (through their acquisition of Hughes Helicopters), the name is an acronym derived from the phrase no tail rotor but uses air to keep the copter from spinning.


Do the wheel studs come mounted on the front brake rotors of a 1988 Ford Thunderbird?

Some do ;just ask your parts supplier to pull the rotor out of the box and check for you.


How do you turn rotors on a 2000 Nissan Frontier XE?

If your rotors need turned (nowadays it's usually better to replace them, and some can not be turned at all), take them to a shop that has the proper equipment. They can look up the specs.


Are brake pads and rotors universal for all types of vehicles?

No, brake pads and rotors are not universal for all types of vehicles. Different vehicles require specific brake pads and rotors that are compatible with their make and model. It is important to use the correct parts to ensure proper braking performance and safety.