answersLogoWhite

0

The CV joint stud should be tightened to at least 220 ft/lb.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the distributor on a 1998 mercury villager?

The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.


Is Mercury villager 1997 front or rear wheel drive?

Front wheel drive


Where is oil filter on 1998 mercury villager?

Bottom front of engine.


Where is the Crankshaft pulley in mercury villager?

It is on the front of the engine on the end of the crankshaft.


Where the thermostat is on your 1995 mercury villager?

In front of the engine, down in the "V".


Where is the front motor mount on 2000 mercury villager?

At the front of the motor attached to the engine cradle.


How do you remove the front wiper arms from a 1997 Mercury Villager?

The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.


Where is the thermostat housing on a 98 mercury villager?

On the front of the engine in the center of the "V".


Where is the number two cylinder on a 1996 Mercury Villager?

On a Mercury Villager , V6 engine : firewall 1-----3-----5 2-----4-----6 front of vehicle > driver


What size windshield wiper blades are used on a 1993 Mercury Villager?

The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.


Where can you find your transmission on mercury villager 1995?

On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine


Is the 1995 Ford Mercury Villager rear wheel drive?

front wheel drive