answersLogoWhite

0

A 1993 Pontiac Sunbird head bolt torque sequence recommends starting at one and of the head and alternating to the other end of the head. You should end up in the middle.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is the torque sequence of a 93 Geo Storm?

Torque sequence of what. Heads, wheels, etc.


Torque specs for heads on 3800 motor?

Head torque sequence for a 2002 3800


What is the torque sequence for 67 429 caddy heads?

its 144


What is the torque specs on the heads for a 1997 Pontiac Transport 3.4L?

115in-ibs


What are the cylinder heads torque sequence for a Toyota 4y forklift engine?

headboltstork


What is the torque specs on the heads to a 2005 pontiac grand am 3.4L?

The torque specifications for the cylinder heads on a 2005 Pontiac Grand Am with a 3.4L engine are typically 37 ft-lbs (50 Nm) for the initial torque, followed by a 90-degree turn on each bolt. It's essential to follow the correct tightening sequence and procedure to ensure proper sealing and avoid warping. Always refer to a service manual for the most accurate and specific guidelines.


What is the torque for 1985 Celebrity heads?

I would recommend that you consult a repair manual for torque values as well as tightening sequence


What is the torque specs for intake manifold on 1972 Pontiac catalina?

40 lb/ft Cast iron heads.


What the difference between 455 Pontiac heads and 400 Pontiac heads?

The primary difference between 455 Pontiac heads and 400 Pontiac heads lies in their design and specifications, which affect performance and compatibility. The 455 heads typically have larger combustion chambers, allowing for higher displacement and more airflow, which can enhance power output. In contrast, 400 heads generally have smaller chambers and different port configurations, which can influence compression ratios and torque characteristics. Additionally, the valve sizes and flow capabilities may vary, making them suitable for different performance builds.


Torque on Ford 302 heads are?

Fist tighten to 50lbs in sequence,rhen to 60lbsin sequence and then to 65-72 ft lbs in sequence. Wait about ten minutes then recheck and tighten to the 65-72 ft lbs.


Need torque pattern for cylinder heads ford 302 heads?

what is the torque pattern for ford 302 heads?


What is the torque specs on an Edelbrock aluminum intake manifold for a Pontiac 428?

Iron Intake to Iron Heads - 40ft lbs Aluminum Intake - 25ft lbs