0
What else can I help you with?
What is the torque spec for a Chevy flexplate?
60 ft lbs and dont foreget the red locktight!
60 series Detroit diesel engine torque spec?
hi what is the sequence and torque on engines detroit diesel 60 series 12.7L 430/470 horse power ...
What is the torque spec for 1973 harley fx rear axle nut?
55 to 60 foot pounds.
What are the torque specs for the upper and lower intake in a Chevy Venture?
AnswerIf this is the V-6, then you must have a common problem...lower intake leaks coolant.The torque spec for the lower manifold is:First pass: 60 inch poundsSecond pass: 110 inch poundsLast (outer bolts only): 18 foot poundsUpper intake is a total 88 inch pounds in at least two steps.Randy
Intake bolt torque specs for 1999 mercury villager?
The 1999 Mercury Milliliter intake bolt torque specifications is 60 pounds per square inch. The intake bolts should be torqued at 30 pound intervals.
What is front axle shaft nut torque spec for 1998 GMC jimmy?
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
What is the torque spec for the pressure plate bolts on a 12.7l 60 series detroit?
55 ft lbs then 120 degrees 55 ft lbs then 120 degrees
What is needed to make a 1995 tbi 350 to a vortec 350?
This is what you will need. Vortec Heads,Intake,distributor,front timing cover,crankshaft sensor and 60 to 66 LB. fuel pump Ect.. If you are talking about putting a vortec engine in a 95 then you will need alot more. Let me know what you are wanting to do and I'll help you.
Will the engine and transmission from a 1994 GMC Jimmy S10 SLE 4POINT3 liter vortec motor fit into a 1999 GMC Jimmy SLT?
the simple answer is YES. though, a 94 would be either a t.b.i. system or early vortec. if it is a vortec, the swap shouldn't require a p.c.m. reflash- however if your 94 is a t.b.i. you will need to change the intake and fuel delivery systems to handle the 60 p.s.i. operating pressure for the vortec engine.
Does a 1997 vortec have the same fuel pressure as a 1990?
No, the vortec will be about 60 psi. The 1990 throttle body system will be about 15 psi.
What spec is the Jake brake leveling screw locknut torque on series 60?
The torque specification for the Jake brake leveling screw locknut on a Detroit Diesel Series 60 engine is typically around 30-35 lb-ft. However, it's important to consult the specific service manual for your engine model, as torque values can vary slightly based on the configuration and year of manufacture. Always ensure that you use a calibrated torque wrench for accurate measurements.
Torque spec on rocker arm shaft on cummins isx?
Tighten to 50 ft/lb,then back off all rocker shafts,then 22ft/lb plus 60 degrees which is one flat of a bolt "hexagon"
