check your main fuses
Remove the positive battery cable from your 1994 Firebird battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Best and easiest way to change battery in any Volkswagen. Remember if your computer loses power it will go into limp mode and you will find yourself at the dealership for vag-com. Have a friend with a good battery and a set up jumper cables and hook cables from his battery to yours, loosen battery terminals on your battery and carefully remove battery with out knocking the cables off (remember keep power to the battery cables on your WW). Carefully install your new battery and tighten the terminals. With jumper cables still hooked to your car start your engine, then remove the jumper cables. I would then take car for a short drive to ensure that there is a full charge to the battery you just installed.
have you checked your cables, esp the ground?
there is a fuselink in the battery lead to the starter that likely blew.
You can purchase battery cables online for a low price. A good place to find these is at discount marine supplies. They carry battery cables and are discounted, too.
Disconnect the Regal battery cables. Find the battery clamp then remove it. Lift the battery out, then put the new one in. install the clamp, then connect the battery cables.
disconnect the battery cables. find the battery clamp and remove it. Lift the battery out, then set then new one in place. Install the clamp, then connect the battery cables.
When using battery cables to start a car, once it has started is there a procedure when removing the cables from the running car?
THe battery is under the back seat so you have to TAke all theose cables out
Take both cables off. Remove old battery. Put new battery in. Put cables back on.
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
The battery on a Toyota Yaris is changed by lifting the hood, loosening the battery cables, and placing them to the side. A new battery is put in place and the cables reconnected.