0
What is wrong with a 1991 Dodge stealth with SOHC that will not turn over replaced stater ignition switch ignition relay Still won't turn over nothing but clicking?
Did you try checking or replacing the battery? Usually clicking when trying to start means dirty battery terminals or a dead battery. That's the first thing to check, before ignition switches, ignition relays, and starters; auto parts stores will check it for free. If it's dirty or corroded terminals, clean them up and try starting again. If it's dead and old, just replace it. It it's a new battery and it's dead, check your charging system (alternator, fuses, belts, etc).
What else can I help you with?
1992 Dodge Stealth that has sit for over a year you replaced the battery and the car will not start only hear a click What could be wrong?
It could be a starter problem....can you tell where the click is coming from? is it the started clicking, or a relay clicking?
How do you remove ignition switch dodge stealth?
uh you pull it out :)
Who invented Blackbird stealth jet?
Lockheed Corporation, now known as the Lockheed Martin.ANS 2 -The Blackbird wasn't a "stealth jet" -it flew high enough at such speeds that it really didn't matter to be stealth, nothing could catch it.
91 stealth es every time you go to start it you hear a sparatic clicking noise can anyone help you?
My 93 Stealth es was doing the same thing..low battery or starter it was on mine, replace both and sound is gone.
Why wont your 93 dodge stealth start turns over no start and it does not have a crank cencor do you need this?
If the 93 Stealth came with a crank sensor but it does not have one now, then it will not start. The sensor shows the ignition coil when to send power to the spark plugs.
1993 dodge stealth ignition module?
Where is the ignition module located on a 1993 Dodge Stealth? Ignition control module is located directly under the coil pack. (where the plug wires run into). It's a small black box, only about 3" X 3", and has two plugs going into it. It's held on by two Phillips head screws, which I use a 90 degree Phillips driver to get to one, and a long screwdriver for the other. You can also take off the bracket it sits on.
What causes a 1993 Dodge Stealth to Misfire on two cylinders?
bad coil pack on cylinders, find or pull ignition wires and you can tell by no loss of power.
Where is the Ignition Control Module located in a 1992 base model Dodge Stealth?
On a 1992 Dodge Stealth Base model with a 3.0 Liter Engine It is located in the base of the Distributer, it has four wires connected to it via a molded plug. this is a source of many problems with a 1992 Stealth. The plug is located right next to the Power steering High presure hose, and on my stealth was chafed in two. It is very hard to see this problem until it is unplugged from distributer.
How tall is stealth?
Stealth is 205m!
What is the verb of stealth?
Stealth has no verb.
What is it when the tail lights stay on and interior lights stay on and make clicking sound on 94 stealth?
The engine is clicking with all of the interior lights on? Dead battery... and for future reference... if there is no clicking= really dead battery and it might not recharge. In that case check the alternator, if the alternator is still good, just buy a new battery. If the battery continues to fail to recharge get a new alternator.
Why does my 1993 dodge stealth has no fire?
check ecm engine controle module icm ignition control module or crank angle censor if is a dhoc distributer if shoc>>>>JAC
