To repair the ignition module on a 1993 Dodge Stealth, first disconnect the battery to ensure safety. Remove the module from its housing, typically located near the ignition coil, by unscrewing the mounting bolts and disconnecting the wiring harness. Inspect for any visible damage or corrosion; clean the connections and replace any faulty components if necessary. Reassemble the module, reconnect the battery, and test the ignition system to ensure proper functionality.
To check the ignition module on a 1993 Dodge Stealth, start by disconnecting the battery to ensure safety. Then, remove the ignition module from its housing, typically located on the engine. Use a multimeter to test the module's resistance according to the specifications in the service manual, checking both the primary and secondary circuits. If the readings are outside the specified range, the ignition module may need to be replaced.
check ecm engine controle module icm ignition control module or crank angle censor if is a dhoc distributer if shoc>>>>JAC
Where is the ignition module located on a 1993 Dodge Stealth? Ignition control module is located directly under the coil pack. (where the plug wires run into). It's a small black box, only about 3" X 3", and has two plugs going into it. It's held on by two Phillips head screws, which I use a 90 degree Phillips driver to get to one, and a long screwdriver for the other. You can also take off the bracket it sits on.
where is the ignition module located in my 2000 dodge 1500 ram van
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
uh you pull it out :)
The engine computer (behind the battery) is the ignition module.
where is a ignitionmodule in a dodge colt a 1993
Your local auto parts store.
Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.
On a 1992 Dodge Stealth Base model with a 3.0 Liter Engine It is located in the base of the Distributer, it has four wires connected to it via a molded plug. this is a source of many problems with a 1992 Stealth. The plug is located right next to the Power steering High presure hose, and on my stealth was chafed in two. It is very hard to see this problem until it is unplugged from distributer.
Autozone