The drain plug on a 2006 Saturn Ion typically requires a 15mm socket to remove. However, it's always a good idea to double-check with a manual or online resource specific to your vehicle, as variations can occur. Make sure to use the correct size to avoid stripping the plug.
17 mm, for sure on the 3.5 L V-6 engine (made by Honda), that's the one I have.
If the drain plug is original equipment, it takes a 17mm wrench or socket.
The oil drain plug bolt on a 2006 Saturn Ion typically has a size of 15mm. It's important to use the correct size socket to avoid stripping the bolt. Always check your vehicle's manual for specific details, as there can be variations depending on the engine type.
The oil drain plug for a 2006 Chevy Cobalt typically requires a 15mm socket for removal. It's important to ensure you have the correct size to avoid stripping the plug. Always use a torque wrench to tighten the plug to the manufacturer's specifications after changing the oil.
You can, or a wrench.You can, or a wrench.
Front passenger side. The plug is facing towards the rear of the car.
If I remember correctly it is 15. Thanks, Wes
Front Passenger side. The plug is facing towards the rear of the car http://www.blurtit.com/q8770788.html
drain plug is at bottom of motor center 15m socket carlos puchades
The oil drain plug on the sump is to the rear of the sump on the side 17mm spanner or socket required to remove Drain plug
Its a 28mm socket.
You can use a 11 centimeter socket to remove the transmission drain plug. The socket should be a five-point socket.