If I remember correctly it is 15. Thanks,
Wes
The oil drain plug for a 2006 Chevy Cobalt typically requires a 15mm socket for removal. It's important to ensure you have the correct size to avoid stripping the plug. Always use a torque wrench to tighten the plug to the manufacturer's specifications after changing the oil.
The socket size for the axle shaft not, on a 2006 Chevrolet cobalt, is three-quarter inch. The socket should be a five-point socket.
It don't have 1.
The lug nut size on a 2006 Chevy Cobalt is typically 12mm x 1.5. You will need a lug wrench or socket that fits this size to replace your lost one. It's a good idea to double-check with your vehicle's manual or a local auto parts store for confirmation if needed.
If the drain plug is original equipment, it takes a 17mm wrench or socket.
You can, or a wrench.You can, or a wrench.
9MM
It's on the bottom of the oil pan, just look for the large nut on the oil pan.
cobalt 2006 fuel pressure pump
How to replace front middle grille in a 2006 cobalt ls
i have a 2007 cobalt ss/sc so i dont know if it is the same but i have use a 1 1/4 socket with a 10" extention.. this might help you... http://www.cobaltss.net/forums/showthread.php?t=22848
The drain plug on a 2006 Saturn Ion typically requires a 15mm socket to remove. However, it's always a good idea to double-check with a manual or online resource specific to your vehicle, as variations can occur. Make sure to use the correct size to avoid stripping the plug.