Remove inside panel and remove the screws. If there are no screws then pry it out with a screwdriver.
With a screwdriver lift the black covering of the center console and remove over the handbrake. Snap back into place.
To remove the air vents on a 2004 Pontiac Grand Am GT, a person will have to pry them out with a screwdriver. Apply gentle pressure between the vent and the dash.
First of all pop the trunk and then use a screwdriver to pull the light out and go to Canadian Tire and purchase a new light.
With an oil filter wrench or the old fashion way by poking a screwdriver through it. If you have the room
with one of those thingys with the curved end at the top and a 25 inch screwdriver.
Use a flat blade screwdriver under the tab to pull straight up. The one on the outside edge is sometimes easier if you remove the side marker light first.
Well in my 2004 ford focus we have a very little radio and you only need a screw driver to un-screw 4 little blots on the sides
To change the number plate light on a 2004 Peugeot Expert, first, locate the light housing at the rear of the vehicle. Use a flathead screwdriver to gently pry off the cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reassemble the housing. Finally, test the light to ensure it works properly before securing the cover back in place.
open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them
Sedan or hatch makes a difference
To replace front side light, first remove headlight as described in owners handbook. Where the book says that there is two prongs that need sqeezing to remove side light, you just need to pull hard! The nice Ford garage showed me this morning. Thanks guys.