If your 1992 Plymouth Acclaim isn't starting and there's no fire, first check the battery to ensure it's charged and the connections are clean and tight. Next, inspect the ignition system, including the spark plugs, ignition coil, and distributor cap for any signs of wear or damage. Additionally, verify that fuel is reaching the engine by checking the fuel pump and fuel lines. Lastly, consider checking the fuses related to the ignition and fuel systems for any blown fuses.
The hampster's dead
Check the ignition coil or the "pick up" located inside the distributor
bad coil, bad plugs and/or wires, check and make sure the distributor plug is still plugged in.
this question should be listed under automobile repair
Check the ballist resister on fire wall !!!!
Check if you're getting fire, next make sure you're getting fuel, and check your timing belt.
Try checking the coil make sure all wiring is hooked up as well as plug wire from coil to distributor if all is hooked up and still no spark have coil tested
No, you might have a bad map sensor, disconnect and try starting the car. The map sensor is located above the power steering pump, attached to the fire wall. With one connector and a hose. F. Garay
Check the camshaft sensor. If the sensor is bad or not getting power, then the engine will not fire and the injector will not get a signal.
you might want to check your coil or your plug wire
In 1992 windsor castle caught fire
Angel Fire - 1992 was released on: USA: 9 September 1992 (Telluride Film Festival)