answersLogoWhite

0

You didn't state what year, but from the best of my knowledge, 20 ft-lbs is standard for all years.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is the spark plug gap on a 1999 Saturn sl1?

.040


1996 Saturn SL1?

timing for spark plug wires for saturn sl1 1996


Which spark plug wire goes to which spark plug for a Saturn 2001 sl1?

http://autorepair.about.com/library/firing_orders/bl-fo-2695.htm which spark plug goes to spark plugs wire set for a Saturn sw 1994


What is the spark plug gap on a 2001 Saturn SL1?

just changed my plugs the gap is 0.44


How do you install cylinder head bolts on a 1996 Saturn?

What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?


Dose your 2003 Saturn Ion sl1 have a tork converter?

All automatic transmission vehicles use a torque converter.


What Causes your 1997 Saturn SL1 to misfire in Cylinder 2?

Bad plug, plug wire, burnt valve, blown head gasket, on that cylinder.


Is there a way to reprogram or reset a Saturn SL1 ignition without going to the dealer?

i have a 2001 Saturn sl1 i have a miss in no 1 cyl i cave changed ingiton coil wires fuel ingetor spark plugs and checked compresson it is ok can you give me a answer


Can a 1999 Saturn SL1 rear passenger side door be used on a 1997 Saturn SL1?

yes


How do you remove the headlight to replace the bulbs on a 2000 Saturn sl1?

How can I replace the headlamp on a 2000 Saturn SL1


Your 2001 Saturn SL1 will not pass emissions testing because it has a cylinder one misfire you tried changing the plugs and wires but to no avail Please help?

Change the coil. Period. Very easy to remove from the vehicle if it's a 4 cyl. Follow that spark plug wire from the spark plug to the other end. What it's attached to you should replace.


Which saturn transmission is compatible with 94 SL1 automatic?

Any Saturn Automatic transmission from 1994-2002 with the stamp of MP6 in the top of the bell housing will work in your 1994 SL1. Do not use transmissions from 1991-1993 because they do not have the casting in the top of the case for the transmission torque strut mount.

Trending Questions
How do you replace a head? Is the 2000-2001 pcm for the dodge caravan compatible with the 2002 pcm? How do you replace a 2001 ford expedition gem module? Where are the airbag sensor located on the Crown Victoria? Where can you find a steering column wiring diagram for a 1982 suburban? Where is starter solenoid located on a 2001 Dodge Stratus? How can you tell if the problem on your 96 Pontiac Sunfire is the Alternator or Ignition switch? How do you replace a diesel engine Chevy Caprice classic? Where is the fuse for security light on a 1999 Pontiac Bonneville? How do you remove a heater core from a 95 ford F250 pickup? When a 96 Geo Metro has a problem of not accelerating over 15 mph is the problem with the transmission or the catalytic converter? Where is the fuel pump relay on a 2006 dodge charger? Where is the signal flasher on 1988 Chrysler lebaron? When setting the timing on a Ford Festiva should you diconnect and block both the top and bottom vacuum tubes on the distributor? How do you tighten the power steering belt on your 1998 mercury villager? Average miles on car a year? Where is the kill switch for a 89' ford van? On a 1990 celica how do you adjust the headlights how high or low they rise because other cars such as the MR2 have a knob behind the headlight? My 1997 Acura 3.2TL heater fan won't work on any speed Heat will come through by gravity though Once in a while fan will kick on then go off after I shut car off what do have to do? Acceleration stalls for a moment after hard stop?