0
What else can I help you with?
Which spark plug wire goes to which spark plug for a Saturn 2001 sl1?
http://autorepair.about.com/library/firing_orders/bl-fo-2695.htm which spark plug goes to spark plugs wire set for a Saturn sw 1994
What is the spark plug gap on a 1999 Saturn sl1?
.040
1996 Saturn SL1?
timing for spark plug wires for saturn sl1 1996
What to torque spark plug on a Saturn sl1?
You didn't state what year, but from the best of my knowledge, 20 ft-lbs is standard for all years.
Where is the starter located on a 2001 Saturn SL1?
The starter on a 2001 Saturn SL1 is located on the driver's side of the engine. It is just to the left and in front of the alternator/generator.
Is there a way to reprogram or reset a Saturn SL1 ignition without going to the dealer?
i have a 2001 Saturn sl1 i have a miss in no 1 cyl i cave changed ingiton coil wires fuel ingetor spark plugs and checked compresson it is ok can you give me a answer
Your 2001 Saturn SL1 will not pass emissions testing because it has a cylinder one misfire you tried changing the plugs and wires but to no avail Please help?
Change the coil. Period. Very easy to remove from the vehicle if it's a 4 cyl. Follow that spark plug wire from the spark plug to the other end. What it's attached to you should replace.
Does the 2001 Saturn SL1 have Fuel Injection?
Yes, it most certainly does.
Is the radiator fan on a 2001 Saturn sl1 a push or pull fan?
PULL
What is the Fram oil filter number for 2001 Saturn SL1?
If you truly like your Saturn use a NAPA gold filter FIL1348
What Causes your 1997 Saturn SL1 to misfire in Cylinder 2?
Bad plug, plug wire, burnt valve, blown head gasket, on that cylinder.
How do you release the spark plug wires from the distibutor block on a 2001 Saturn SL1?
I just changed the wires on a 2000 SL1. If yours is the same - you will see 2 plastic brackets, each holding a pair of wires. Mine had a screw that had to be removed from each of these brackets. It would appear these brackets are designed to hold the connections securely to the distributor block. Once you remove the screw fully you will be able to disconnect them. hope this helps.
