Use a "torx" head screwdriver.
To remove the front dash of a 2000 Saturn, start by disconnecting the battery to ensure safety. Then, remove any screws or clips securing the dash, typically found around the instrument cluster and along the edges. Carefully pry off the dash panel using a trim removal tool to avoid damaging the clips. Once loose, disconnect any electrical connectors and remove the dash completely.
You need a special tool to remove it . The tool slides between the door and the handle and pushes the clip out
Located in the fuel tank, and requires special tool to remove.
You need to pull the plastic cover over the visor swing joint straight down. On each end of the oval cover there is a small groove to allow you to insert a tool with a 90 degree bend into to grab both ends at the same time. Once this piece is pulled down and removed the spring clips holding the visor on are unlocked. Just pull the visor out of the connector housing.
12
8mm square. Now, where do we find the tool?
twist it counter clockwise. A oil filter remval tool may be needed
To replace the brake pads on a 2000 Saturn L Series, you will typically need a few essential tools, including a lug wrench to remove the wheel, a C-clamp or brake caliper tool to compress the caliper piston, and a socket set to detach the caliper from the bracket. Additionally, having a torque wrench is useful for reassembling the components to the manufacturer’s specifications. Safety glasses and gloves are also recommended for protection during the job.
To change the light in the sun visor of a 1998 Volvo S90, first, locate the small cover or lens on the visor where the bulb is housed. Gently pry it open using a flat tool or your fingers. Remove the old bulb by pulling it straight out, then insert the new bulb in the same socket. Finally, snap the cover back into place, ensuring it is secure.
rear wheel alighnment on a Saturn requires a special tool available at Saturn or through most large tool companies.
use the special tool for that
It's an Inline metal filter under the car and you need a special snap arround tool to remove it.