What tools are needed to replace secondary air pump on 2001 Oldsmobile intrique
It is pretty technical and special tools are needed. Take it to a garage.
A 2000 Oldsmobile Alero V6 requires 6.8 quarts of Dexron III fluid.
4.25 Liters or 4.5 Quarts.
350 Big block?
You have an idle control problem. Try the following: 1) clean the throttle body. 2) replace the IAC 3) check the TPS and replace if needed 4) locate and seal any vacuum leaks 5) fix any misfire or worn camshaft
To determine the amount of primary current needed to supply the first secondary winding, you would typically use the transformer equation, which relates primary and secondary voltages and currents. The equation is ( V_p / V_s = I_s / I_p ), where ( V_p ) and ( V_s ) are the primary and secondary voltages, and ( I_p ) and ( I_s ) are the primary and secondary currents, respectively. By rearranging this equation, you can solve for the primary current ( I_p ) needed to supply the secondary winding based on the known values of the transformer’s voltages and the secondary current. Additionally, efficiency and losses in the transformer should be considered when calculating the actual primary current required.
dexron 111 atf
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
Tools needed to replace front brakes 2002 Ford Focus?
A certified birth certificate is needed to replace the lost SS card of a minor.
The fuel pressure of a 1999 Oldsmobile 3.8 liter V6 is 35 psi. A fuel pressure gauge is needed to measure the fuel pressure.
To replace the blend door motor on a 1998 Oldsmobile Bravada, first disconnect the battery to ensure safety. Remove the dashboard or center console components as needed to access the blend door motor, which is typically located behind the dashboard. Disconnect the electrical connector from the motor and remove the mounting screws to take out the old motor. Install the new motor by reversing the steps, ensuring everything is securely fastened before reassembling the dashboard and reconnecting the battery.