answersLogoWhite

0

Your basic combination wrench set and 3/8" drive socket set should get the job done.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove starter solenoid wires from 1992 Chevy S10 blaze when space is lacking for tools?

Remove the two bolts holding the starter to the engine then you should be able to drop the starter down enough to take the wires off and remove the starter.


What tools do you need to remove a starter for 94 Oldsmobile achieva?

Common hand tools.


Is it hard to install a starter for 2000 Chevy blazer?

With the right tools and knowledge, no.


Where is the starter located on a 2001 e240 v6 Mercedes-benz?

how to remove a Mercedes e240 starter motor and which tools


How do you remove the radiator in a 2006 Chevy Cobalt?

with the correct tools


How do you remove the transmission on a 1989 Chevy Caprice Classic Brougham?

with tools


What kind of extensions tools do you use to remove the starter?

4" to 6" all depend on what car.


What tools are required to change starter on 96 Saturn?

To remove car parts, a person must have the right tools. For a person to remove a starter on a 1996 Saturn they would need a 1/2 inch socket, a 4 inch extension, a wrench, and pliers.Ê


What tools do you need to change a starter on a 1994 Ford Bronco 302?

all you need are wrenches to disconnect battery cables, and sockets and extensions to remove starter blots from starter


How do you remove 2005 Chevy Avalanche rear bumper?

With a few simple inexpensive tools.


Where is starter on 1996 Chevy S10 4 cylinder and how difficult it to replace?

The started on a 1996 Chevy S10 4 cylinder is located under the battery and to the right. With the right tools and time it is not hard to replace.Ê


How do you remove a flathead starter?

To remove a flathead starter, first disconnect the battery to ensure safety. Then, locate the starter, typically mounted on the engine block, and remove any retaining bolts or nuts using appropriate tools. Carefully disconnect the wiring harness and any solenoid connections before lifting the starter out of its mounting position. Finally, inspect the area for any debris or damage before installing a new starter, if needed.