Common hand tools.
how to remove a Mercedes e240 starter motor and which tools
Remove the two bolts holding the starter to the engine then you should be able to drop the starter down enough to take the wires off and remove the starter.
I am about to attempt this same procedure on my 97 also, according to the Haynes Manual, theres a screw on the parking brake handle that you have to remove, and one on the shifter also, after that its just a bunch of plastic fastners. once you remove the console and the floor panels, its supposedly just held in by 2 clips. So I would say no, no special tools
starter on this car should be simple 12pt metric socket and wrench set range from 10mm- 19mm and a pair of jackstands or ramps
4" to 6" all depend on what car.
To remove car parts, a person must have the right tools. For a person to remove a starter on a 1996 Saturn they would need a 1/2 inch socket, a 4 inch extension, a wrench, and pliers.Ê
all you need are wrenches to disconnect battery cables, and sockets and extensions to remove starter blots from starter
BRING SOME TOOLS TO THE JUNK YARD--GO PRACTICE.......
You buy tools and install it!
Simple! 1. disconnect the battery 2. Crawl under vehicle and remove two 14mm bolts holding starter. 3. Remover signal wire from solenoid 4. Remove main power wire 5. Bring new starter under vehicle with you 6. Replace signal wire 7. Replace power wire 8. put starter into hole. 9. Tighten two 14 mm bolts that hold starter 10. Attach battery 11. Set clock on radio 12. Clean tools 13. Bandage cuts on knuckles Piece of cake!
What tools are needed to replace secondary air pump on 2001 Oldsmobile intrique
the bolts that hold the starter on should be 9/16, so just a wrench, or socket/ratchet. the wires should be 3/8. if not, you can usually take those off with a pair of channel locks, or adjustable pliers.