answersLogoWhite

0

Since the blower motor draws so many amps it cannot be controlled by a simple contact. Instead it receives it's voltage from a relay that opens to brake the electrical flow and makes to turn it on. The contacts in this relay can easily handle the current. Find the relay for the motor and replace it. It has pitted and is hooked closed allowing current to flow even after the key is shut off.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Can you use a tester for GBI 22v leaf blower to check a spark on ignition?

can i use a tester for GBI 22v leaf blower to see their a spark on ignition on blower


Why does a 1994 Chevy Astro Van motor keeps running after ignition is turned off?

The blower resistor is internally shorted to power and needs to be replaced.


Blower motor runs with ignition off?

probablly a bad ignition switch or blower motor not sure on that should run without power


Should the air induction blower continue to run after furnace blower motor starts?

If you are refering to the inducer motor( the one with the little wheel that you see when you take your units doors off) Yes it should keep running when your blower motor is running and before ignition to create your draft and during to rid the gases out your flue Hope I kept it simple


The blower motor of a air handler unit is considered an ignition source?

Yes. The blower motor of an air handler unit can be considered as an ignition source.


Is the blower motor of an air handling unit is considered an ignition source?

Yes. The blower motor of an air handling unit can be considered as an ignition source.


1997 Thunderbird LX Blower always runs when ignition is on.?

It is supposed to run on the lowest setting when the ignition is on.


Why does the blower motor only work on high even when the ignition is off?

it's a problem with the blower motor resistor,


When your glovebox is open in your dodge caravan se 2000 you hear this strange noise like a pump is running what is it?

If you are hearing it while the ignition key is in the on position then it is the blower motor running on low speed. It can also be the air distribution motors resetting themselves.


How do to remove an replace weed eater blower fl15000le lgnition module?

To remove and replace the ignition module on a Weed Eater blower FL15000LE, first, ensure the blower is turned off and disconnected from any power source. Remove the screws securing the ignition module, usually located near the engine, and carefully detach the wiring harness from the module. Install the new ignition module by connecting the wiring harness and securing it with screws, ensuring proper alignment. Finally, reassemble any parts you may have removed and check for proper operation before use.


What are the uses for a Stihl blower?

The uses for a Stihl blower are to remove items that can be easily removed by air. For example, you can blow away leaves in your driveways with the blower.


Where is the blower motor located on a 95 Mitsubishi Galant?

AnswerIt's located in the dash behind the passenger airbag assembly. Remove the glovebox to access it. THE BLOWER ASSEMBLY IS LOCATED UNDER THE DASH AREA WITHIN THE CONSOLE COVERAT THE FLOORBOARD AREA. THE BLOWER HOUSING SHOULD BE REMOVED WHERE THE BLOWER CAN BE REMOVED.