answersLogoWhite

0

Try replacing the throttle body. (I think that is what it is called) I picked one up at a junkyard for like 20 dollars. Good Luck.

PEACE

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What would cause a 1999 Chevrolet 350 to have no spark?

typically this means the ignition module is bad


What could cause a Chevrolet Cavalier to stop running suddenly?

sounds like the ignition control module


Why would a 2005 Chevrolet Cobalt not start?

after replacing the stearing colum what would cause it not to start. You may have disconnected the ignition switch.


What happens when the module goes out on the 1988 Chevrolet celebrity?

What happens depends greatly on which module fails. If the engine control module (computer) fails it may cause the engine to run poorly or not at all. If the ignition module fails the engine won't start.


Does ignition module cause engine to not start?

The ignition module will send a signal when the key is turned. If the module is no good the signal is not sent to the other ignition parts,thus not allowing the car to start


What would cause no spark on a 1999 Honda Civic EX after replacing spark plugs and wires?

Likely Culprits: Bad Coil. Bad Ignition Control Module. Great Resources:


What would cause a 2001 Silverado to start then instantly die?

ignition module


What would cause a 2000 Chevrolet blazer's transfer case module to go bad?

Corrosion. Check connection at the module for corrosion.


Bad ignition module is also causing of not starting?

A bad ignition module will cause a no start situation in a vehicle because the needed spark is not created. It is responsible for telling the distributor when to fire.


Would a bad ignition module cause no fuel pressure in a 95 lesabre?

nope


Will an electronic ignition module going out cause your car to stall while you are driving it?

Absolutely.


What is code P1682 for Chevrolet Trailblazer 2006?

Code P1682 for a 2006 Chevrolet Trailblazer indicates a problem with the ignition switch-related circuits. Specifically, it suggests an issue with the ignition switch signal not being detected by the engine control module (ECM). This could result from a faulty ignition switch, damaged wiring, or poor connections. It's important to diagnose the specific cause to ensure proper vehicle operation.