answersLogoWhite

0

P0141 is heated oxygen sensor circuit malfunction

you need to check the supply voltages to the sensor.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What can cause a 98 Camaro 3.8 to stall unexpectedly while driving sometimes it could be 5 minutes or even two weeks before it stalls again I've had the ignition control module replaced twice?

crank sensor is getting hot/ bad crank sensor


What is causing P3081 code on a VW 03 Passat after sensor replaced twice?

The P3081 code on a VW 03 Passat typically indicates an issue related to the coolant temperature sensor circuit. If the sensor has been replaced twice and the code persists, the problem may lie in the wiring or connectors associated with the sensor, such as frayed wires, poor connections, or corrosion. Additionally, the engine control module (ECM) could be malfunctioning or may need a software update. It's advisable to perform a thorough inspection of the wiring and connectors to identify and resolve any underlying issues.


What would cause a 2000 Plymouth Neon to overheat when you have replaced the thermostat twice and the sending unit?

Water pump not pumping or a pluged radiater


1995 Pontiac Bonneville it will die going down the road and start right back but jerks you have replaced mass air sensor fuel pump fuel filter crank sensor and injectors cleaned Any ideas?

This has happened on my 97 twice- it was the fuel pressure regulator.


How often is liver tissue replaced?

twice a year


Anti lock brakes warning light 2001 alero?

wheel bearing and sensor need replaced. another of GM's wonderful (notice the sarcasm) products. have had my car 4 years and have had to replace both twice.


What is causing your 1997 ford 3.0to miss fire on number 3 and 6 you have replaced plugs the coil twice and wires twice it still misses under a load till you reach speed and let off the gas?

a vacuum leak is possible. plugged cats. bad o2 sensor. etc.


How do you reset the oxygen sensor check engine light on a 91 dodge stealth?

Any time you have to reset the ECM, all you have to do is disconnect the negative battery cable for about 15 seconds--if you've replaced the sensor--I just had to do that twice--the first one apparently was bad so I had to buy another one and now that fault is gone.


What could cause a brake light circuit failure in a 1998 BMW 328i if the bulb has been replaced twice already?

I'm having the same problem! Just got a ticket for mine.


89 Buick Regal 2.8 trouble shifting getting to 65 miles pH and dies when it comes to a stop. replaced converter with a new one a year ago and it has burn up replaced mod. valve tran filter spark plugs?

Have you replaced the fuel filter? Have you run a computer diagnostic test? The fuel filter was replaced last year in march. have not ran diagnostic test yet. someone said it may be the oxygen sensor due to the catlettic converter going out twice in one year. still do not know why it is dying at light and not wanting to shift. am replacing O2 sensor today.


How do you replace a crankshaft position sensor on 2003 Nissan Altima?

These were covered under a Nissan factory recall. Call the dealer, let them know about the recall for the crack shaft sensor, and it should be a free replacement. I have a 2002 Altima and actually had to get mine replaced twice...both at the dealer...both free of charge due to the recall on the part.


What commander was replaced twice by Lincoln in the civil war?

George B. McClellan