answersLogoWhite

0

What else can I help you with?

Related Questions

Does the ABS breaking controller continue to be powered when the vehicle is not running?

The ignition switch has to be on for the ABS to operate.


How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?

Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.


How do you remove the ignition switch in a 1988 Isuzu pickup?

how to remove lock cyliner switch 1988 Isuzu pickup


How doi remove ignition without key from 1986 Toyota pickup truck?

Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.


Where is the ignition switch on a Mazda pickup?

by the steering wheel


How do you change the ignition switch in a 1998 Tacoma pickup?

How_do_you_remove_the_key_cylinder_in_a_98_Toyota_tacoma


Why is it your 306 hdi run on after you switch off engine?

A 306 HDI may continue to run after you switch off the engine if the ignition timing is set improperly. This will force the engine to continue running for several seconds.


How do you switch out ignition switch on a 1985 c10 Chevy pickup 4x4?

Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you change ignition switch on 1995 Mazda pickup?

The ignition switch on a 1995 Mazda pickup is changed by partially removing the steering column to reveal the switch on the side of the column. It can then be unbolted from its mounts, the wires disconnected, and a new switch put in place.


Why does my Car engine continue running when the ignition is switch off?

It sounds like your dizzy cap isn't lined right which causes the engine to stay running after the ignition has been switched off. i had the same problem with my fiesta


How do you remove ignition switch on 1989 Toyota pickup?

To remove the ignition switch on a 1989 Toyota pickup, first disconnect the battery to ensure safety. Then, remove the steering column cover by unscrewing the screws that hold it in place. Next, locate the ignition switch assembly, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the ignition switch out and replace it if necessary.


How do you remove the ignition switch on a 1990 Chevy half ton pickup?

how do you remove the ignition switch on a 1990 chevy half ton pick-up?