answersLogoWhite

0

I had the exact same problem with my 2000 grand prix gt, you need to replace the gear box assembly.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

No sound at all turning ignition key?

It is a clicking sound


What is the number 2 position when turning the key on a Honda accord?

Accessory position. Radio will play but ignition is still off.


How do you install the ignition switch in a 2004 Pontiac grand am?

The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.


How do you know if somthing is wrong with your front passenger axel 2003 Pontiac Aztec?

if you have a bad axle they will usually make a clicking noise when turning


Why Ford expedition doesn't start only makes clicking sound when turning ignition?

Check battery, charge it or change it. Dead battery.


Why does a 2000 Pontiac Bonneville not start in the morning?

low fuel presure. try priming it by turning ignition on and off several times.


Why do I hear a clicking noise when turning the key in the ignition then on the 3rd try the car does start?

The clicking noise you can hear is the starter solenoid clicking into place. If the starter motor does not turn the engine immediately, it is probably the best place to look. it sounds like the starter motor is faulty.


Why turning my ignition on and wont turn off?

Turning my ignition on and wont turn off because it is faulty.


Does the ACC wire connect to the ground wire?

No it doesn't. The acc wire on your stereo is for accessory from your ignition switch. That's so you can turn your car key back and run your stereo without turning on the engine.


Do the cigarette lighters stay on after the car is off on a 1998 ford explorer?

Yes , the socket is live so you can use the cigarette lighter without starting the Explorer or turning the ignition key to the accessory position


Where is the ignition switch on a 2004 Pontiac Grand Am?

The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.


How do you reset oil change lamp 2005 Pontiac?

try turning the ignition key to on (don't start) and depressing the gas pedal 3 times within 5 seconds.