0
What else can I help you with?
Fuse marked meter blows out apon starting car no brake lights or turn lights?
A loose or corroded ground wire will cause the fuse to blow. Check the ground wires on your brake lights.
Why don't the left side running lights work on my 2000 Cherokee sport?
If the right side lights are working and all left side lights are out, its as simple as this: Electricity is not reaching the bulbs. Use a volt meter (with the lights on) and check a bulb socket. if there's around 12 volts registering on the meter, then you have power to the light socket and the bulb(s) is/are bad. If there is no power to the socket, that sucks because now you have a wiring issue to chase down. This should be a relatively simple repair as long as u have a volt meter.
What is landlord meter?
In most states, the landlord is forbidden from having the tenant pay for lights in the common area. The landlord should have a separate meter for those lights.
Why don't the fog lights work on a 1999 Jeep Cherokee Sport?
i had the same problem with my jeep. it ended up being the switch, but there are many other problems that can cause your fog lights to not operate properly. check first to make sure they are not burnt out. then i'd check all your connectors to make sure there is no corrosion and that they are making good contact. next step is to put a meter on it and see if you are getting power to the lights. if not you've obviously got an open or a short in your wiring somewhere. check for a broken wire, faulty switch, etc.
Could the Mass Flow Sensor cause 1993 Ford 1.9 liter Escort LX to have no power buck and stalling at red lights?
Disconnect the air flow meter and see if the fault eases if so it is more than likely a air flow meter fault.
Why there is a multiplier in electric meter?
Cause there is ...
What would cause the brake lights in a 95 civic to never come on even though the tail lights work and the fuses are good?
There may be a cut in the wire(s). You will need a Digital Volt Meter to test the wire(s) at your brake light. There is a switch that is actuated when you apply pressure to the brake pedal. If the switch is malfunctioning your lights won't come on.
Is it cheaper to turn off fluroescent lights or leave them on?
It is cheaper to turn lights off. You can check by having one person outside at the electric meter. See what happens when you turn off the florescent lights. See what happens when you turn them on. Does the meter speed up? If is speeds up does it speed up more than enough to make up for the time the lights were off? Write it up for a science project.
How do you detect the cause of an open circuit?
Ohms Meter
Your tail lights dont work but everything else does?
check bulbs with meter. check to see if connectors are loose on light. short in wire leading to lights. check fuses.
Can a power surge cause an dramatic increase in the KWH reading of a digital meter?
A power surge is unlikely to cause a significant increase in the kWh reading of a digital meter because the meter measures the amount of electricity consumed over time, not the voltage of the electrical supply. Power surges can cause damage to electronic devices but typically won't directly impact the kWh reading on a meter.
Why does the voltage meter drop and lights get dim when you turn on the defrost or ac on your 1999 Jeep Cherokee?
The simple answer is - your battery is getting old ! Batteries don't last forever - over time they lose their ability to retain a charge. The symptoms you're describing is that the electrical system is asking for more power than the battery is able to provide.
