You've lost a soft-plug (freeze plug). A very inexpensive part, but on many vehicles replacing it requires removing the engine from the frame or separating the engine from the transmission.
Measures the temperature of the water in your engine block, usually right where the water comes in from the radiator.
Could be a leak in a radiator hose, or radiator. ==Answer 2, Another Possibility== It could also be the radiator cap pressure relief valve action which vents coolant and/or coolant vapor to the coolant overflow reservoir/tank when steam is created in the coolant passages in the engine block. When the engine is shut off, the residual heat in the block can cause the additional pressure and/or steam.j3h.
The coolant comes from the engine at it's hottest through the top radiator hose, cooling as it goes lower and lower in the radiator until it comes out the bottom radiator hose at it's coolest temperature and back into the engine.
Check coolant level in coolant recovery tank and radiator
The check coolant light ( if equipped ) is located between the engine temperature gauge and the tachometer near the bottom . It comes on when the engine coolant reservoir is too low and looks like a box with a radiator on top and has an " X " shaped fan in the box
Look at the radiator. Follow the large coolant hose that comes out of the top of the radiator and follow it down to where it connects to the engine block. The housing that the hose connects to on the engine contains the thermostat.
engine coolant willleak from hose if you remove,it. if nothing comes out, then obviously there is not enuff coolant in the system to operate correctly
Probably not. There really is no way to increase the flow in the radiator, but when it decreases the coolant does not get cooled down as quickly thus the coolant gets even hotter. If the flow in the radiator decreases too much you could have an engine over heat which is bad news bears when it comes to the lifetime of your engine.
This is one of the simplest jobs you can do on an Accord. You will need a 10mm box-end wrench and a jug of Honda Genuine coolant - accept no substitutes.Turn your heater controls to the full-on setting and pop the hood. Find the upper radiator hose and trace it back to the engine. On the place where it goes in (the thermostat housing) you will find a bleeder nipple. Take the radiator cap off, open the nipple and start pouring coolant into the radiator until a steady stream of fluid comes out of the nipple. Then close it quick, make sure the radiator is full, and put the radiator cap back on.
There is a plastic drain valve on one of the bottom corner's of the radiator (facing engine) open valve and properly catch & dispose of coolant that comes out. You may need to use pliers to loosen drain valve. Tighten by hand.
Sounds like you have a coolant leak. When cold, put a pressure tester (hand pump with fitting to the radiator neck) and see if you can see any coolant leaking. Once found, fix the leak.
coolant is not circulating - open the heater and bleed the system ++ Another Answer ++ If the lower radiator hose is installed correctly and the hose clamp is tight and the "coolant comes almost all out ... like from the bottom of the engine", you may have a bad freeze plug that either rusted or popped out. You might want to get under the vehicle and inspect the bottom part of the engine. CAUTION: Be sure and block all wheels to keep vehicle from rolling over you.