The wiper motor has a sensor plate under the wiper links above the motor they go up instead of down if this is not making the contact it needs to tell if the wipers are in position replace this and your problems will be solved
Turn the wipers off, pull the wiper arm off, and replace it in the correct down position.
The control lever for wipers on the Transit is able to move up and down (for operating the front wipers), but also can be moved towards and away from the driver to control the rear wipers. Push the wiper lever away from you (while seated in the driver seat) to turn off rear wipers.
remove wiper arms from vehicleturn wipers onthen turn wipers offshut off ignitionreplace wiper arms at the down positionthis should be the return position when ever u shut wipers off
The linkage for the wipers could have slipped. If the linkage is not aligned right, then the wipers will not stop at the right spot.
the delay on jetta wipers is different. the delay is adjustable. if someone set the delay very long, you will think the delay is not working. here's how to shorten the delay. turn the wipers to delay (one click DOWN on the stalk). immediately turn it back off and now turn it back on. the delay is the length of time you had the wipers off between the two on's. for a 3 second delay, turn the wipers to delay, immediately turn them off, wait three seconds and turn them back on. for a 6 second delay, turn them on, immediately turn them off, wait 6 seconds and turn them back on.
A bad relay switch will cause the windshield wipers to not turn off. Replace the relay switch and the windshield wipers should turn off.
remove the wipers, turn on wiper switch, turn off switch, reinstall wipers @ bottom position torque nuts enough to secure the arm. turn on switch readjust as needed.
first remove wiper arms from vehicle next with ignition on, turn wipers on then off. the wiper motor will stop at the down position. replace wiper arms onto shaft ,in the correct down position where you want them. now with ignition on, try wipers again,to check if in the stop position you want them.
The head light wipers come on when you turn your regular wipers on.We own a Mercedes not because of people think its a status symbol,We have them because they are solid!!!
If the windshield wipers work when pushing the lever down but not when they are turned on all the time, the problem could be in the wiper motor relay switch. There are two different relay switches for the windshield wipers, so that if the one fails a person can still clear the windshield manually.
1. Set the blades at a position that is easy to work on. To do this turn the key on and turn the wipers on. When the wipers are straight up and down turn the key off. 2. Lift the blade from the windsield. Press the coil spring with a small screwdriver to release the blade. Move it back and forth and take it off. Press the new blade onto the arm pivot pin. Make sure the spring holds the blade to the pin. 3. Turn the key on and turn off the wipers. 4. You got 'er done.
it is on the same lever you turn your front wipers on with but you twist the the last inch of it