0
What else can I help you with?
How do you bleed the air out of the coolant system on a 1997 Pontiac Montana?
If it has bleeder valves then use them to bleed the system, if not, jack up the front of the vehicle as high as possible. Remove the radiator cap and start the engine. Add coolant to keep the system full. This will allow air to escape.
How do you bleed air out of coolant system 97 Saturn?
procedure on how to bleed air out of coolant system on 97 saturn ls
What might cause a 1999 Pontiac Montana to overheat you flushed the radiator and changed the radiator hose What else?
Thermostat, water pump, defective cooling fan, or cooling fan thermo switch. The coolant system needs to be bleed so that all the air is removed. There are two bleed off valves located that need to be losened until all the air is removed from system. The owner's manual shows where the bleeder valves are located.
How do you bleed your V6 coolant system?
how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......
Where is the place you bleed coolant system?
It is not necessary to bleed the coolant system. If you mean "drain" the system, there is usually a plastic plug on the radiator or, you can pull the lower radiator hose off.
How Do you Bleed The Coolant System On A 1998 Beetle?
To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.
How do you bleed air from the cooling system of a Toyota Tacoma?
If you see bleeder valves on the cooling system use them to bleed the system. Otherwise, remove the radiator cap, turn the heater control to hot, start the engine, keep the coolant topped off, and watch until no more air bubbles are escaping.
How do you replace the thermostat located on a 1991 Pontiac Bonneville 3800?
I believe you want to drain the coolant, remove the top hose at the thermostat housing, remove the housing, replace the stat and gasket, reassemble fill with coolant and bleed the system.
How do you bleed the coolant system on a 2002 impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
How do you Bleed the coolant system on a 2002 Chevrolet Impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
How do you bleed coolant system after replacing thermostat?
what is the year make & modle of it??
How do you bleed the coolant system on a 1999 mercury villager?
Not necessary on this vehicle.
