On a 1998 Jeep Cherokee Sport, the grease fittings, also known as zerk fittings, are typically located on the front suspension components, such as the upper and lower ball joints, tie rod ends, and the steering linkage. Additionally, there may be fittings on the U-joints of the driveshaft. It's important to consult the vehicle’s service manual for specific locations and maintenance recommendations.
The original parts had no grease fittings.
Zero from the factory.
It wasn't built with any.
Not with original equipment. Some replacement parts may have.
they are everywhere...any where there is a joint or working, encased, parts.
Yes, there are only grease fittings on the lower control arm ball joints one each side. It seems that some were delivered with these grease fittings and some just had thread plugs instead.
It had zero from the factory. Aftermarket steering or suspension components could have them.
There is 11 grease fittings in the front end parts. You have 1 fitting in the front driveshaft, could have 1 in each u-joint. There may be fittings in the rear drive shaft too. There is 11 in the front Suspension for sure, and that is not counting the driveshafts.
1998-2001
I haven't found any on mine. Looked everywhere.
yeah it will just make sure u install it right
5 on 5x4.5