You can't. I been searching for one and called a few different car part places nobody had it. Then called the dealership and they said they didn't make it but I could buy the whole linkage part for around $140.00. Your best option is going to a junk yard and get one out of a car there or improvise something.
Advanced Auto Sells a bushing kit
You can try Quadratec.com, Rockauto.com, or your local jeep dealer
How do you remove and replace wiper switch on 2002 Chevy Cavalier
To change the wiper bushing on a 1986 Dodge D-150 truck, first, lift the wiper arms away from the windshield and remove the nuts securing the wiper arms using a socket wrench. Once the arms are off, detach the wiper motor cover to access the wiper linkage. Replace the old bushing with a new one, ensuring it fits snugly, then reassemble by reversing the steps: reattach the wiper motor cover and wiper arms, and secure them with the nuts. Finally, test the wipers to ensure they function properly.
The linkage bushing is located under the Crowl grill. Remove wipers and grill.
To replace the wiper linkage bushing on a 1994 Dodge Dakota, first, disconnect the negative battery cable to ensure safety. Remove the wiper arms by unscrewing the retaining nuts and gently pulling them off the shafts. Next, remove the screws or bolts securing the wiper linkage assembly, and detach it from the vehicle. Replace the worn bushing with a new one, reassemble the linkage, reattach the wiper arms, and reconnect the battery.
Its has a bushing and should be replaced everything the clutch is being replaced, as a set!
Broken linkage or bushing in the wiper system.
Replace plastic bushing.
Begin by removing the traveling arm retaining bolt from your 1998 Chevrolet Cavalier wiper motor. Remove the wiper motor retaining bolts. Remove the wiper motor wiring harness. Reverse the process to install your new wiper motor.
To replace the wiper linkage bushing on a 1994 Dodge Dakota, begin by removing the wiper arms using a puller tool if necessary. Next, detach the plastic cover and the wiper linkage assembly by unscrewing the bolts securing it to the firewall and disconnect any electrical connectors. Replace the worn bushing with a new one, reassemble the linkage, and ensure everything is securely fastened before reattaching the wiper arms and testing the system. Make sure to check for proper movement of the wipers after the installation.
They are not if you have a press...