answersLogoWhite

0

on the front tires its a few inches behind tire wheel well , you should see a notch / indentation for your jack . Put your jack in the middle of the indentation . Same thing for the rear except its located a few inches in front of wheel well .

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you get to the side mirror switch on a 2002 Dodge Intrepid?

To get to the side mirror switch on a 2002 Dodge Intrepid look on the driver side door. The mirror switch is located just above the window up and down switches.


Can you put in a 1998 Dodge Intrepid 2.7l engine into a 2000 or 2002 Dodge Intrepid?

Yes you can but, you have to use the flywheel off of the 2002 engine on the 1998 engine other than that you just have to hook up the wiring harness off the 2002 onto the 98.


Where are the Jack points on Dodge Intrepid?

Raise the Intrepid. Lift up on the front jack point with the floor jack. Use the front jacking point behind the radiator. Place jack stands under the pinch welds on either side of the vehicle's body underneath the front doors. Then lower the Intrepid onto the stands.


Where is the starter on a 2002 Dodge Intrepid with 2.7L engine?

underneath the car. somewhere near where the engine and transmission hook up.


If the timing chain is off on my 2002 Dodge Intrepid will that stop it from cranking up?

If the timing chain is off, you will probably have bent valves.


Will driving with low oil lock up a Dodge Intrepid?

Yes


2002 Dodge Intrepid with a code P1794 replaced both speed sensors the code still comes up Why?

One of the pig tail for the speed sensor has a crack in it and/or not grounded


Will a 1994 Dodge Intrepid motor fit in a 1995 Dodge Intrepid?

As long as they are the same size and all the plumbing and eletrical line up. A 3.3 liter into a 3.3 liter, for example.


Why is it that your Dodge Intrepid sputters backfires when its cold but when the temps are up it runs fine?

sensor


How do you open the hood on a '96 Dodge Intrepid when the interior latch lever does not work?

pull on the cable slowly with increasing pressure it should open or jack up the car and poke at it with a long screwdriver or pliers


How hard is it to remove an oil pan of a 2000 Dodge Intrepid 2.7?

Depends on what you know.The engine needs to be raised as high as in can.this is especialy hard when on the ground because you cannot jack up on the pan.Once you get it up,its a little tricky but you can wiggel it out.


How do you fix a seat belt in a 1984 Dodge Intrepid that will not roll back up?

replace the seat belt