After learning that our Ford dealer would charge us $40 to tell us the factory unlock code, I looked on the computer module. The code sticker is NOT on the front of the module. However, I was able to locate it on the back. Here's how:
Remove the three hex head screws under the front edge of the panel below the steering column. One of the screws is behind the hood release lever. The panel is also attached with clips at the top edge; just pop these out.
The computer module is the same black box that has the fuses -- it says "pull" on the front where you can take the lid off to change fuses. The factory keypad code sticker on our car is on the BACK of the box, near the left side. Tos see it, I had to partially remove the box.
It's not necessary to unplug any of the cables from the box, but you need to remove the three nuts that secure the box. They are 10mm nuts, & you'll need a deep socket. One nut is at the bottom, one at the top near the upper right corner, and one on the left near the top. That last one is the least accessible, but it's not too difficult.
Get the nuts off, pull the box forwards until you can reach behind it with a small hand mirror to read the code. It's a 5-digit number & should be obvious. The numbers will be backward (in the mirror) and possibly upside down, so note carefully. I had a hard time figuring out whether one digit was a 6 or a 9, so I just tried it both ways, also forwards and backwards, until one of the combinations worked.
Then just replace the nuts & the dash panel, & use the factory code to reprogram the keyless entry code as explained in the manual. Be sure to write down the factory code somewhere safe.
find body control module its on that
Where is the PCM located on a 2005 Mercury Montego Premier?
where is the outside temp sensor located on a 2005 ford freestyle
The GEM module is to the left of the steering column.
It is located behind the motor on the firewall.
The Engine Control Module (ECM) on a 2005 Ford Freestyle is located in the engine compartment, specifically on the driver's side near the firewall. It is typically mounted to the side of the engine bay, making it accessible for diagnostics and repairs. Always ensure the vehicle is turned off and properly secured before attempting to locate or service the ECM.
Its located on the passengers side of the vehicle............
The daytime running light module on a 2005 F-350 is located underneath the hood. The module will be in the relay box.
The computer module, also known as the Engine Control Module (ECM), on a 2005 Ford Explorer Sport Trac is typically located in the engine compartment, near the battery or on the passenger side fender well. It may be secured with bolts or clips and covered by a protective shield. For precise access, it's advisable to consult the vehicle's service manual or seek assistance from a professional mechanic.
The computer module, also known as the Engine Control Module (ECM) or Powertrain Control Module (PCM), on a 2005 Ford Five Hundred is typically located in the engine compartment. It is usually mounted on the passenger side, near the firewall or fender area. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle’s service manual for precise location and removal instructions.
In a 2005 Chevy Trailblazer, the engine control module (ECM), commonly referred to as the computer, is located under the hood. Specifically, it is mounted on the driver's side of the engine compartment, near the firewall. Accessing it typically requires removing a few components for better visibility and reach.
It is located underneath the car, below the passenger-side center-row seats.