The EGR valve is mounted on the rear of the engine. It is connected to two pipes, just above the bell housing.
on a 2.5l it is mounted on the intake plennum in the back against the firewall
It's behind the manifold on the driver side
EGI.. do you mean EGR?
is your car is a v6 2.7 it will be on the trans mission by the EGR
You need to take the intake manifold off and radiator
Start and stall out, possibly. Not start at all, not likely.
it is part of the egr valve
I can't provide diagrams, but I can describe the location of the EGR valve on a 2004 Chrysler Pacifica. The EGR valve is typically found on the engine's intake manifold, near the throttle body. It’s a small, metal component connected to the exhaust system, usually with a vacuum line or electrical connector attached to it. For precise location and identification, consulting the vehicle’s service manual or an online repair guide is recommended.
It is part of the EGR valve on the driver side of the rear cylinder head.
The EGR (Exhaust Gas Recirculation) valve on a Chrysler Sebring with a 2.4L engine is typically located on the intake manifold, near the throttle body. To access it, you may need to remove any engine covers or components obstructing your view. It's important to disconnect the battery and any electrical connectors before proceeding with removal or replacement. Always refer to the vehicle's service manual for specific guidance and diagrams.
location of egr valve on 04 grand am v6
Left Front of engine on top of alt.