CPS is located above the starter on the back side of the engine held in with a 10mm bolts.
Nothing...........there is none.
The 1998 Saturn SL2 will show a code 340 and 341 for a camshaft position sensor because this part is also considered the crankshaft position sensor on the Saturn. The location of the crankshaft position sensor is behind the alternator on a 1998 Saturn SL2. Both crankshaft and camshaft are the same thing This vehicle is not equipped with a camshaft position sensor. Saturn is the only manufacture that uses a auto pulse generated inside the ignition control module in conjunction with the pulse received from the crankshaft position sensor to determine ignition and injection timing. If you have a code for camshaft position sensor the issue is with the pulse generator in the ignition control module.
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
http://www.youtube.com/watch?v=JC0U53w_Htk Video by Richpin
The Saturn SL2 was produced from the years 1990 to 2002 in the United States. The best way to tell if the fusible link in a 1999 Saturn SL2 is fried is that there will be no 12v.
There is none.
It has none.
ON my 1999 sl2 it is the transmission fluid dipstick
vacaum leak or bad throttle position sensor. gm Jim
assuming your talking about the sensor that operates the speedometer, there should only be 2.
Yes it does.
Where is the speed señor for a 94saturn sl2