The coolant temperature sensor on a 2002 Oldsmobile Intrigue is typically located near the engine block, specifically on the intake manifold or cylinder head. To find it, look for a small, cylindrical sensor with an electrical connector attached, usually situated near the thermostat housing. It's advisable to refer to a repair manual or diagram for precise location details if needed.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
Its either your cam shaft position sensor or the crank sensor.
depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.
looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.
The radiator drain cork for a 2002 Oldsmobile Intrigue is located at the bottom of the radiator on the driver's side. It typically resembles a small plastic or metal screw or plug that can be unscrewed to allow coolant to drain. Be sure to have a container ready to catch the coolant when you remove it, and ensure the engine is cool before attempting to drain the radiator.
2002 was the last model year that Oldsmobile Intrigues were produced. The Intrigue was the first Oldsmobile to end production in the process of phasing out the Oldsmobile brand. The last Intrigue rolled off the factory floor in June of 2002.
Bottom of the engine
pull out the fuse
show location of camshaft position sensor for 2002 Oldsmobile bravada.
2002 bravada oldsmobile
Check your battery cables. I had same issue