In the right front passenger footwell , by the kick panel
In the right front passenger footwell , by the kick panel
In the front passenger footwell by the kick panel
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
To reset the combination lock on Eddie Bauer luggage, first, locate the reset button, usually found near the locking mechanism. Open the luggage and press the reset button while setting your desired combination by turning the dials. Once the new combination is set, release the reset button to save the new code. Make sure to test the lock before closing the luggage to ensure the new combination works.
In the right front passengers footwell , by ( or behind ) the kick panel
The fuel pump inertia (shut off) switch is located in the right front passenger area. It is in the footwell near the right foot kick panel. (Helpfull)
To reset the Eddie Bauer Ford Explorer after changing the batteries, start by turning the ignition to the "On" position without starting the engine. Then, press and hold the gas pedal for about 10 seconds to reset the engine control module. If necessary, disconnect the negative battery terminal for a few minutes and reconnect it, which can also help reset the vehicle's systems. Finally, check that all electrical components are functioning correctly.
the fuel reset switch is under the passenger side kick panel on the firewall you have to pull off the plastic panel to get to it.
In the right front passengers footwell , by the kick panel
My Explorer won't turn over; the lights come on and attempted to jump the vehicle. Where is the fuel bottom if engine does not turn over?
There is a small hole on the underneath side of the rearview mirror. You have to use a paperclip to push the reset button inside and turn the vehicle in slow, short circles until it resets.
Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it! Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it!