Subjects>Auto>American Cars

Where is fuse for speed odometer and gas gauge on 2000 chrysler sebring?

Anonymous

∙ 14y ago

Updated: 6/25/2025

In a 2000 Chrysler Sebring, the fuse for the speedometer and gas gauge is typically located in the fuse box under the dashboard on the driver's side. You should check the owner's manual for the exact fuse number, but it is usually labeled as "Instrument Panel" or "Gauges." If the gauges are not functioning, inspecting and replacing this fuse may resolve the issue.

AnswerBot

∙ 2mo ago

What else can I help you with?

How to Set idle speed on a Chrysler sebring 1999?

Idle speed is not adjustable on this car.

How do you change the idle speed on a 2002 Chrysler Sebring?

Idle speed is computer controlled and is not adjustable.

Where is the odometer cable in a 1996 Chrysler town and country?

A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.

How do you adjust the idle on a 2008 Chrysler Sebring?

Idle speed is computer controlled and is not adjustable.

What does a 1997 Chrysler sebring speed sensor look like?

Go to Kragen.com and search for speed sensor. You will find a picture of it.

What is the proper idle speed in a 2001 Chrysler Sebring lxi?

600-1000 depends on temperature and load.

How do you adjust the idle speed on a 2006 Chrysler sebring?

Idle speed is computer controlled and is not adjustable.Idle speed is computer controlled and is not adjustable.

Name a gauge on your car's dashboard?

1. fuel gauge or gas gauge 2. RPM gauge or tachometer 3. Speedometer or Speed Gauge 4. Oil gauge 5. Odometer 6. Electrical gauge 7. Temperature gauge

What type of transmission fluid is used on a 1997 Chrysler Sebring convertible auto 4 speed?

Molar ATF+4

How do you change the idle on a Chrysler Sebring?

Idle is computer controled and is not adjustable. Id the speed is incorrect there is a sensor or actuator malfunction.

How do you set idle on a 2004 Chrysler Sebring?

Idle is computer controlled and is not adjustable. If the speed is incorrect there is a sensor or actuator malfunction.

Where is the vss wire on a 2007 chrysler sebring?

There isn't a vehicle speed signal wire on a 2007 Sebring. The transmission computer uses its input and output sensors to factor vehicle speed. It then transmits that message over the communication wires of the vehicle.

Trending Questions

How to replace front blower motor 2001 Sienna? Where is the oil pressure sensor located on a 2003 silverado 2500hd 6.0 liter truck engine? How do you take off the door panel on a 1997 Chevy Cavalier? How do you shut off esp on a 2007 dodge charger RT? What is the difference between a Corvette and a dead baby? What type of coolant is used in a 1997 Cadillac Seville? What is wrong when your '95 Buick Regal heater-defogger vent puts out heat on the driver's side and cold air on the passenger side? How do you change oil on a 1993 jeep grand Cherokee? What proof do you have that Henry Ford was antisemetic? How do you change alternator on ford 500? What is the cost of a brand new Dodge Ram 2500? What does a code p2179 in a Cadillac CTS? How do i determine if my ignition key has a chip? Where is the fuel pump located on 1995 Buick Le Sabre? If your speedometer on a 1989 Dynasty works but the odometer doesn't work how do you fix it? How do you call another name of car dicky? How do you replace starter on 2001 Cadillac DeVille? How many passengers can be in a car in Ohio? Where is the fuel pump relay in a 1998 Buick century? How do you set the timing on a v6 2.7 liter Dodge Intrepid that will not start after replacing the water pump?