In the power distribution center under the hood. It is the 30 amp fuse also there are 2 relay's there.
Under the black cowling at the base of the windshield.
If its like a 96 you remove the windshield wiper motor and assembly
All 1996-2000 Plymouth Voyagers take 28" replacement windshield wiper blades on both sides front.
there was a factory recall on one of the wiper motors.
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
On a 1997 Plymouth Voyager, the relay for the rear wiper is found under the hood. It is in the fuse housing on the passenger side.
The windshield wiper motor is located just below the windshield wiper blades and is covered by a black panel.
The 1999 Plymouth Grand Voyager takes a fairly standard 18" rear wiper blade (also takes 28" replacement windshield wipers on both sides front). Additionally, the installation process is simple. The replacement wiper blades will come with step-by-step, illustrated removal and installation instructions.
One could purchase a windshield wiper motor at a retailer such as AdvanceAutoParts. Alternatively, one could also purchase a windshield wiper motor online on Amazon or AutoZone.
The windshield wiper motor may have a short in it. The windshield wiper motor may not be grounded properly. Make sure the ground wire is tight and free of corrosion.
# Remove the windshield wiper arms # Remove the cowl cover # Disconnect the electrical connector from the wiper motor # Detach the wiper motor/linkage assembly from the cowl # Remove the wiper motor retaining bolts and remove the motor
* Remove the windshield wiper arms * Remove the cowl cover * Disconnect the electrical connectorr from the wiper motor * Detach the wiper motor/linkage assembly from the cowl * Remove the wiper motor retaining bolts and remove the motor