0
What else can I help you with?
Where is the multi function switch on a 2002 Dodge Dakota?
"Multi-function switch" usually refers to the turn signal/wiper control module which is located on the steering column at the base of the signal/wiper control lever.
Can the multi-function switch be changed in a dodge ram 1500 without removing the steering wheel?
YesYes
What is multi-service switch?
what is the function of the switch ? and what does it do ?
Where is the multi function switch on 1999 cadillac?
turnsignal/wiper switch
2001 Mercury Grand Marquis Flasher Location?
Internal to multi-function switch. Multi-function switch is mounted with two bolts. This will be a 5 minute repair.
1998 Dodge Gr Caravan has a wiper Ghosting problem Comes on and off at different times will replacing the multi function switch fix the problem?
We had that problem. I was the clockspring in the steering column. Eventually the airbag light came on and cruise control stopping working. Bought our Caravan used and discovered there was an old recall that had not been done. Check the internet, you should not have to pay to get the dealer to fix it.
Where is the multi purpose switch 1988 ford ranger?
The multi function switch is inside the steering column , for turn signals etc.
What does the multi switch in a 1996 ford Crown Victoria do?
Your multi function switch is mounted inside your steering column cover The turn signal lever is part of the multi function switch , as is the hazard flasher switch - these are visible outside of the steering column cover Your turn signal lever / multi function switch operates : - turn signals - high beams - flash to pass - windshield wipers - windshield washer
Where is the 2004 Chrysler Sebring multi-function switch?
Turn signal headlamp switch
How do you change the multi function swith on a 1994-2001 dodge ram?
# Disconnect and isolate the battery negative cable. # If the vehicle is so equipped, remove the tilt steering column lever. # Remove both the upper and lower shrouds from the steering column # Remove the lower fixed column shroud. # Move the upper fixed column shroud far enough to access the rear of the multi-function switch # Remove the tamper proof mounting screws (a Snap On tamper proof torx bit TTXR20B2 or equivalent is required) that secure the multi-function switch to the steering column. # Gently pull the switch away from the steering column far enough to access and remove the multi-function switch wire harness connector screw. # Unplug the wire harness connector from the multi-function switch. # Reverse the removal procedures to install. Tighten the fasteners as follows: #* Multi-function switch wire harness connector screw - 2 N·m (17 in. lbs.) #* Multi-function switch mounting screws - 2 N·m (17 in. lbs.)
Where is the location of the multi-function switch on a 1997 thunder bird steering column?
I am assuming the "multi-function" switch is the TURN SIGNAL/HI-LO BEAM/WIPER CONTROL SWITCH. It is located on the left side of the steering column.
Where is the multi function switch on a 2001 Chrysler Sebring?
The multifunction switch is the turn signal switch and whatever else is part of it.
