answersLogoWhite

0

"Multi-function switch" usually refers to the turn signal/wiper control module which is located on the steering column at the base of the signal/wiper control lever.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is multi function switch on a 1999 dodge caravan?

It is the turn signal/wiper switch


Can the multi-function switch be changed in a dodge ram 1500 without removing the steering wheel?

YesYes


What is multi-service switch?

what is the function of the switch ? and what does it do ?


Where is the multi function switch on 1999 cadillac?

turnsignal/wiper switch


2001 Mercury Grand Marquis Flasher Location?

Internal to multi-function switch. Multi-function switch is mounted with two bolts. This will be a 5 minute repair.


What does the multi switch in a 1996 ford Crown Victoria do?

Your multi function switch is mounted inside your steering column cover The turn signal lever is part of the multi function switch , as is the hazard flasher switch - these are visible outside of the steering column cover Your turn signal lever / multi function switch operates : - turn signals - high beams - flash to pass - windshield wipers - windshield washer


Where is the multi purpose switch 1988 ford ranger?

The multi function switch is inside the steering column , for turn signals etc.


Where is the 2004 Chrysler Sebring multi-function switch?

Turn signal headlamp switch


How do you change the multi function swith on a 1994-2001 dodge ram?

# Disconnect and isolate the battery negative cable. # If the vehicle is so equipped, remove the tilt steering column lever. # Remove both the upper and lower shrouds from the steering column # Remove the lower fixed column shroud. # Move the upper fixed column shroud far enough to access the rear of the multi-function switch # Remove the tamper proof mounting screws (a Snap On tamper proof torx bit TTXR20B2 or equivalent is required) that secure the multi-function switch to the steering column. # Gently pull the switch away from the steering column far enough to access and remove the multi-function switch wire harness connector screw. # Unplug the wire harness connector from the multi-function switch. # Reverse the removal procedures to install. Tighten the fasteners as follows: #* Multi-function switch wire harness connector screw - 2 N·m (17 in. lbs.) #* Multi-function switch mounting screws - 2 N·m (17 in. lbs.)


Where is the location of the multi-function switch on a 1997 thunder bird steering column?

I am assuming the "multi-function" switch is the TURN SIGNAL/HI-LO BEAM/WIPER CONTROL SWITCH. It is located on the left side of the steering column.


Where is the multi function switch on a 2001 Chrysler Sebring?

The multifunction switch is the turn signal switch and whatever else is part of it.


What is a multi function switch on a 1995 Monte Carlo?

The term "multi-function switch" on a vehicle usually refers to the stick (or sticks) on the steering column that controls turn signals, wipers, cruise control, etc.