answersLogoWhite

0

On the 2.8 / 2.9 / 3.0 the number 1 position on the distributor cap is at the back , towards the firewall and towards the passenger side of the motor

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the 1 cyl on an 1984 Fiero dist cap?

The firing order on a 2.5 Pontiac motor is 1-3-4-2, 1 being in front. The chilton book shows the firing order and the wire placement on the dist cap. #1 is at 10 oclock.


Spark plug layout for 1989 Ford Ranger?

4 cyl = firing order 1342, # 1 is front cylinder 6 cyl = firing order 142536, # 1 is passenger front cylinder, dist. rotation clockwise


How do you find 1 on the d cap if ther firing order is 1-6-5-4-3-2 on 1991 Chevy 4.3L?

rotate the engine to top dead center on the compression stroke on number one cyl. remove the dist. cap the rotor bug will be pointing at the number one on the dist cap. if the cam and crankshaft are timed right. timing on the wires are clockwise on the cap


Want to adjust idle on 98 metro 3 cyl dist cap seems to be firmly attached with no way to turn like normal car Thanks?

Timing and idle are computer controlled and not adjustable


How do i know where to put the firing order on the distributor cap?

After bringing your engine to top dead center, line the distributor up so the rotor faces the number one cylinder. Rotate the dist. so the closest terminal lines up with the rotor. This will be your number one in your firing order. Mark that terminal #1. Tighten the dist. in place. Put your wire from the cap to #1 cyl. Now follow the firing order for the rest of the wires. The dist. rotates clockwise so put the wire on the next terminal on the left and route it to the next number cyl. in the firing order. Do this till all are connected. Here is a link to help. http://www.classiccarauto.com/impala/how_to/install_distributor.shtml


Will a 1996 Ford Ranger transmission fit on a 1989 Ford Ranger?

what does a fuel pump look like in a 1989 ford ranger 4 cyl.


How do you replace the rad hoses on a 1996 Ford Ranger?

How do I remove air from the cooling system of a 95 ford ranger 4 cyl


What is the firing order on 2002 ranger 4.0 l dohc?

1,3,4,2 is the firing order of my 2001 4 cyl 2.5ltr ranger.


What is the 1 cylinder on a 1996 dodge ram truck and what is the 1 position on the distributor?

driver frt cyl and dist points to pass frt


What side is 1 cylinder on a 3.3L V6 Nissan?

Right front when looking down from top, with pulley in front. If it has a distributor, which most of these 3.3's do, it will also show #1 cyl on the cap, beside the terminal that the spark plug wires plug into. Easy to trace out where it goes: Right Front cyl. However; If a cheap dist cap was installed, it might not have the wires numbered. It's interesting that most Technical Specs books these days, like AUTODATA books, which cost a lot, DO NOT have this information in them.


Where can you find a wiring diagram for the spark plug wires on a 1999 Honda CR-V?

This will also work for the 2.0L engine as well as it has the same configuration as the 2.2L According to a manual, 4 cyl. firing order is 1-3-4-2. #4 cyl. being closest to distributor. On dist cap #1 is top right position on 2.2L engine, and is the bottom left position on 2.3L.


Does 2007 ford ranger 4 cyl has timing belt or timing chain?

Timing CHAIN