The powertrain control module (PCM) on a 2000 Ford Windstar SEL is typically located in the engine compartment, mounted on the passenger side, near the firewall. It is often positioned near the battery and may be covered by a protective cover. To access it, you might need to remove any obstructions, such as the battery or air intake components. Always refer to a service manual for exact details and safety precautions.
Powertrain Control Module
Powertrain Control Module
There is not a stand-alone ignition control module in the Windstars.Ignition control is fully handled by the Powertrain Control Moduel (PCM).See "Related Questions" below for more
In a 1998 Ford Windstar, the powertrain control module (PCM) is typically located in the engine compartment, mounted on the driver's side, near the battery. It is housed in a metal enclosure and connected to various wiring harnesses. To access it, you may need to remove the battery or other components for better visibility and clearance. Always consult the vehicle's service manual for detailed instructions specific to your model.
Powertrain Control Module (PCM)
If you're looking for a stand-alone ignition controlmodule, there isn't one on the Windstar.This job has been transferred to the Powertrain Control Module (PCM) and its direct control of the coilpack.
PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.
in glove box
The powertrain control module, is located on drivers side under dash, it is white!
A 1997 Wrangler doesn't have a BCM. (body control module) It does have a PCM (powertrain control module) which is behind the battery.
The powertrain control module is one of the electronic control modules used on a vehicle. Others include antilock brake, airbag, transmission, body,
The ecm or engine control module aka powertrain control module is located on the floor under the dash. You can pick up used ones on ebay...