0
The purge solenoid on a 2003 PT Cruiser is typically located near the engine, mounted on or near the intake manifold. It is part of the evaporative emissions control system and is connected to the charcoal canister, which is usually found underneath the vehicle near the fuel tank. To access it, you may need to lift the vehicle or remove some components for better visibility. Always consult a repair manual for specific details and diagrams.
What else can I help you with?
Where is the purge solenoid PT Cruiser?
Under the car at the power steering swith~gear!
Where is the shift solenoid on a 2003 turbo pt cruiser?
The solenoid pack is on the front of the transmission case below the cooler hoses.
Where is the purge valve located on the 2003 PT Cruiser?
Hello,L/s lower right in front of rack
Where is the solenoid pack on a 2003 Chrysler PT Cruiser?
It is on the front of the transmission case. It is the block below the cooler hoses.
What does the code p0760 mean for 2003 pt cruiser?
Trouble code P0760 means: Shift solenoid C malfunction
Where is the solenoid switch valve on a 2003 Chrysler PT Cruiser?
The solenoid switch valve on a 2003 Chrysler PT Cruiser can be found above the transmission oil pan on the driver's side of the transmission. You may need to remove the air filter housing, battery, and battery tray to access it for better visibility.
Will shifting solenoid make noise when its going out 2001 pt cruiser?
When a shift solenoid goes bad the solenoid doesn't make any noise.
Where is the solenoid pack on a 2001 PT Cruiser?
It is on the front of the transmission, below the cooler hoses.
If the solenoid pack in a PT Cruiser leaks must it be replaced?
It is not repairable and should be replaced.
Where is shift solenoid on 2001 PT?
remove battery & case and you will see solenoid attached with three 10 mm bolt head & one elect attachment
Transmission light in pt cruise came on...what could this be?
switch or possible shift solenoid problem
Where is shift solenoid on 2001 PT cruiser?
remove battery & case and you will see solenoid attached with three 10 mm bolt head & one elect attachment
