Under the car at the Power Steering swith~gear!
To check the purge flow on a 2004 PT Cruiser, first locate the purge solenoid, which is typically found near the engine or on the intake manifold. With the engine running, disconnect the purge line from the solenoid and use a vacuum gauge to measure the vacuum pressure while the engine is at idle. If there's no or insufficient vacuum, the solenoid may be malfunctioning. Additionally, you can check for any leaks in the vacuum lines or inspect the solenoid for proper operation.
The solenoid pack is on the front of the transmission case below the cooler hoses.
It is on the front of the transmission, below the cooler hoses.
It is not repairable and should be replaced.
When a shift solenoid goes bad the solenoid doesn't make any noise.
Hello,L/s lower right in front of rack
The purge solenoid on a 2003 PT Cruiser is typically located near the engine, mounted on or near the intake manifold. It is part of the evaporative emissions control system and is connected to the charcoal canister, which is usually found underneath the vehicle near the fuel tank. To access it, you may need to lift the vehicle or remove some components for better visibility. Always consult a repair manual for specific details and diagrams.
It is a valve in the valve body, inside the transmission.
It is on the front of the transmission case. Just below the cooler hoses.
It is on the front of the transmission, just below the cooler hoses.
It is on the front of the transmission case. It is the block below the cooler hoses.
remove battery & case and you will see solenoid attached with three 10 mm bolt head & one elect attachment