Behind the glove box.
The transmission control module and engine control module are one part and are located under the hood.
The transmission control module is located under the drivers seat.
The combination of the front control module and the under hood fuse box is called the integrated power module.
Im trying to figure out how to replace my heater modual in my 2006 gmc, I have the part just need a diagram of where exactly it is located in my truck.
How do you change the wiper control module on a 2006 Ford Focus
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
where is the block heater cord located on a Mazda 3 2006
There are many reasons. A bad Thermostat. A bad Heater Core. A Bad Control Module. Turn off the radio and IF you have the Climate Control Module, switch from AC to heat and listen carefully to see if you can hear the ducts moving inside the dash. If you can, then the Control Module is working and your down to the other two possibilities. Good Luck.
I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.
The computer module, also known as the Powertrain Control Module (PCM), in a 2006 Ford Freestyle is typically located in the engine compartment, near the battery and the driver's side fender. It may be mounted on the firewall or attached to the engine itself. For precise identification, it's recommended to consult the vehicle's service manual or a professional mechanic.
The ignition switch is part of the WCM (wireless control module).The ignition switch is part of the WCM (wireless control module).
The heater control valve on a 2006 Chrysler Pacifica is typically located near the firewall, on the passenger side of the engine compartment. It is connected to the heater hoses and regulates the flow of coolant to the heater core. To access it, you may need to remove some components for better visibility and reach. Always consult the vehicle's service manual for specific instructions and safety precautions.