answersLogoWhite

0

The cam position sensor is located on the passenger's side of the engine. You must remove the Power Steering pump to remove it. With the power steering pump removed, the sensor is visible directly on top of the intake valley. It has a 6-8 inch pigtail with a three wire electrical connector on the end Some of them have an 8mm bolt holding them on and some of them have a 10 mm bolt, depending on build date. Extreme care should be used when removing the sensor because they will break off into the block easily. If the sensor does break, screw a drywall screw into it, and use pliers to pull on the drywall screw. Install is reverse of removal.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the o2 sensor located in a 92 Chevy Corsica?

In the exhaust system before the catalytic converter.


What is a MAP sensor on an 2002 Chevy Trailblazer?

The MAP sensor on a Trailblazer is the Manifold Air Positioning sensor. It is located on the top of the engine.


Where is the cam position sensor located on a 1988 Chevy Corsica?

CLICK THE SITE AUTOZONE.COM ON THE RIGHT ---> IT SHOULD HELP YOU


Where is the crankshaft positioning sensor located on a 2003 Chevy suburban 5.3L?

Same as the Tahoe behind the starter


Where is the tps sensor located on a 2002 Chevy 8.1 liter motor?

the throttle positioning sensor is located under the gas petal on the side of the bracket that the petal bar is attached to


Where is the crank sensor located on a 1988 4 cylinder Chevy Corsica?

It will be on the back side of the engine where the distributor used to be on older engines.


Where is the throttle position sensor located on a 1991 Chevy Corsica 2.2L 4 cylinder?

its behind the coil packs on the back of block


Where is the over drive solenoid on a 1989 Chevy Corsica?

where is the over drive solenoid located on a 1989 Chevy Corsica


How do you replace the water pump on a 1990 Chevy Corsica 2.2L?

Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?


Where is the crankshaft sensor on a Chevy Blazer?

The crank shaft positioning sensor should be located at the front of the engine just below and to the left of the harmonic balancer. On the timing cover.


Where is the crank sensor located on your 1989 2.8liter Chevy Corsica?

behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.


Where is the trunk release for a 1990 Chevy Corsica located?

in the glovebox.