answersLogoWhite

0

V6 crank position sensorThe crank position sensor is part of the distributor on a V6

All Fieros equipped with a distributor (1984 - 1986 4-cyl and 1985 to 1988 V6) have the crank sensor inside the distributor. It may also be known as a distributor pickup or HEI pickup.

Fieros with DIS (1987 to 1988 4 cylinder) have a crank sensor on the back side (engine side) of the ignition module extending into the engine block. The ignition module is the flat base that the ignition coils are attached to.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the fan sensor located on the 1986 4 cylinder fiero?

this should help you out! Brian


Where is the throttle position sensor on a 1986 Fiero?

it's on the side of the throttle body(3 prong plug)


Where is the MAP sensor located on a Pontiac Fiero GT 2.8L V6?

MAP Sensor LocationOn a 1987 Pontiac Fiero GT 2.8L V6. It is bolted to the end of the intake plenum on the passenger side of the engine compartment.


Where is the crank position sensor on a 88 fiero V6?

Call autozone and they will have a diagram of where this is. also in the haynes manuel the is a location showed for you


How do you install the throttle position sensor on a 1987 Pontiac fiero?

To install the throttle position sensor (TPS) on a 1987 Pontiac Fiero, first disconnect the negative battery terminal to ensure safety. Remove the electrical connector from the old TPS, then unscrew the sensor from the throttle body. Position the new TPS in place, aligning it properly, and secure it with screws. Finally, reconnect the electrical connector and the battery terminal, then check for proper operation.


Where is the speedometer sensor in a fiero?

on the transmission


Where is map sensor located?

The Manifold absolute pressure sensor on a fiero V6 is mounted on the passenger side manifold right beside the thermostat assembly/water outlet


Where is the coolant temp sensor on a 1987 Pontiac fiero gt?

where is the coolant temperature sensor locate


Where is the MAT sensor located on the 87 fiero GT 2.8?

it sits on the intake manifold on the right side looking at the car from the rear..its a black plastic looking box, attached directly to the intake.


Where does the o2 sensor go on a 1988 Pontiac fiero?

Standing straight up in the drivers seat.


Where is the Turn-Stop Relay located on a 1984 Fiero?

There is not one


Where is the speed sensor on a 4-cylinder '87 Fiero?

You will see it screwed right in there in the top of the tranny with 2 wires coming off. It's a pretty large sensor so it's fairly obvious. Just run into any AdvanceAuto Parts store and check out the Haynes manual for a Fiero. It's in there. You should a manual already if you own a Fiero or you should get one! ;-)