answersLogoWhite

0

Call autozone and they will have a diagram of where this is. also in the haynes manuel the is a location showed for you

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the crank position sensor in a 1995 olds delta 88?

on a 1994 it's behind the harmonic balancer


How do you install a crank sensor to harmonic balancer on a eighty-eight delta royale 88 Oldsmobile?

To install the crank sensor on the harmonic balancer of an '88 Oldsmobile Delta 88, first ensure the engine is cool and disconnect the battery. Remove the harmonic balancer by loosening the bolt and using a puller if necessary. Position the new crank sensor in its designated mounting location, aligning it properly with the harmonic balancer’s signal wheel. Finally, secure the sensor, reconnect the battery, and test the installation for proper function.


Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?

on the front of the motor under the front crank it has a plug going to the crank.


Where is the crank angle sensor located on the 88 GL hatchback?

It is integrated in the distributor.


Why won't my 1986 fiero strart?

my 88 fiero had two valves stuck, one on cyl 2 and one on cyl 3.. if it would start it was on one or two cyl... or he crank senor might be bad


What would make a Jeep Comanche pick up not have ant fire to the plugs?

My problem on the 88 I was working on turned out to be the crank position sensor located on the driver side top of the bell housing.


How to locate a cam position sensor for a 88 trooper?

it's built into the distributor


What can i do to get a 88 Oldmobile cutlass supreme to start i just had the coil packs changed what else could it be?

Check the crank sensor


1998 Oldsmobile 88. has no spark replace the igniton control module. what else could it be?

crank or cam sensor...did you already figure it out?


Where is the crank sensor on a 1999 Oldsmobile 88?

On a 1999 Oldsmobile 88, the crankshaft position sensor is typically located near the lower front part of the engine, often on the engine block near the crankshaft pulley. To access it, you may need to remove any obstructions, such as the engine cover or other components. The sensor is usually mounted with a couple of bolts and connected by an electrical connector. Always refer to the vehicle's service manual for specific details and procedures.


What would cause a 98'Olds 88 to not start 3 mechanics can't fix it?

depending on what year I have researched and found my 94 olds 88 has a gm commonly failing part called a Crank Shaft position sensor it is located behind the tensioner pully cost me $200 to have it tested and replaced and I haven't had a problem since


What is the setting for a crank prosion sensor on a 1990 olds 88 3800?

The setting is you better have good eyesight! It has to be positioned between the fins on the back of the cranshaft dampner.